L-Body shift linkage kit sale!

[ajakeski]

We lowered the price of our L Body Shift linkage kits to $50 for SDAC 21 last week.
For those who didn't make the show, we are going to extend that sale until July 31st.

For any shift linkage orders made on or before July 31st the price will be $50 plus $5.00 shipping.

http://www.greatlakeshotrod.com/Great_Lakes_Hot_Rods/L-Body_Shifter_Kits_For_Sale.html

[boost geek]

Hmmmmm, tasty.....:eyebrows:

[PunKid]

We lowered the price of our L Body Shift linkage kits to $50 for SDAC 21 last week.
For those who didn't make the show, we are going to extend that sale until July 31st.

For any shift linkage orders made on or before July 31st the price will be $50 plus $5.00 shipping.

http://www.greatlakeshotrod.com/Great_Lakes_Hot_Rods/L-Body_Shifter_Kits_For_Sale.html

I dont think you will be sending out refunds to people who bought a few month back huh :eyebrows:

Anyways I did want to comment that I got my kit installed and worked great. The only thing I wanted to add was after pounding out the old Ball studs to run a 3/8" drill bit through the hole. The new Ball Studs would not install unless I did this.

[ajakeski]

I dont think you will be sending out refunds to people who bought a few month back huh :eyebrows:

Anyways I did want to comment that I got my kit installed and worked great. The only thing I wanted to add was after pounding out the old Ball studs to run a 3/8" drill bit through the hole. The new Ball Studs would not install unless I did this.


Sorry, the sale isn't retroactive.
As for drilling out the holes, you're right about that. It's mentioned on page two of the instructions as well.
http://gallery.me.com/ajakeski/100213/Shifter-20Kit-20Instructions-20page-202/web.jpg?ver=13099804880001

[ajakeski]

Only 15 days left!

[Turbo224]

Am I going to need to thread the shift rods for this conversion? This is for the 525 trans, correct? The thread nor the website clarifies this.

[PunKid]

yes you need to thread the rods

[zin]

I'll have to see if I have enough $$ before the end of the month!

Mike

[ajakeski]

Am I going to need to thread the shift rods for this conversion? This is for the 525 trans, correct? The thread nor the website clarifies this.

The instructions included with the kit specifies exactly what needs to be done for the conversion.
Each kit includes instructions.
The thread size for our quick disconnects is 3/8 x 24

[ajakeski]

9 days left to save $10.That's two good beers, or a crappy case of beer.

[ajakeski]

5 days left!