View Full Version : Lean out on deceleration
tryingbe
06-02-2011, 12:16 AM
I'm using LM V12.5. Which table do I adjust to lean out on deceleration? When I am on the off ramp, cruising to a stop while in gear, the a/r is usually 11-12. How do I adjust it to 16-17?
Thanks.
GLHNSLHT2
06-02-2011, 12:43 AM
I shut off all the fuel above idle vacuum in the fuel no throttle table.
tryingbe
06-02-2011, 11:30 PM
Where is the fuel no throttle table found? I don't seem to find it. I am using the LM V12.5
http://www.thelostartof.net/tryingbe/dodge/omniproject/nothrottle.jpg
shackwrrr
06-03-2011, 07:08 AM
click on the dot that says Name (where it says groups/name/Type) and then scroll down. It isnt in the fuel section since its not normally used.
tryingbe
06-03-2011, 09:55 AM
Checked it, there isn't a table name "fuel no throttle" or close to it.
click on the dot that says Name (where it says groups/name/Type) and then scroll down. It isnt in the fuel section since its not normally used.
shackwrrr
06-03-2011, 10:01 AM
Ill check when I get home. I looked in V10 and it was there, unless rob changed the name of it for some reason?
GLHNSLHT2
06-04-2011, 12:54 AM
I don't know where it is, I am still using Rob's old T1 based cals. It's right next to the fuelpartthrottle and fuelfullthrottle tables in those cals.
I don't understand. You posted a picture of FuelBaselineFromMap and that is the one you want to adjust to shut the fuel off in decel.
I have my fuel adjusted so it shuts off on decel but I'm using a SMEC. Swing by the shop or when you return my tools and I can show you how mine's adjusted.
A.J.
GLHNSLHT2
06-04-2011, 10:53 AM
oh yes, fuelbaseline from map is the same as the old Fuelnothrottle table.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.