trying to find a table that works with this bin

[bakes]

Im trying to find a table that works with this bin ( came for my car when i bought it ) i would like to get this to work so i can overlay the tables to my new cal
This is a 2.2l 3bar +40 mtx
30765

[bakes]

I have open this but all the talbes had like 50-100 points and lines everwhere!

[zin]

LOL! At first I thought you were looking for a piece of furniture! I've got a couple of mystery cals as well, almost threw them out figuring I'd never be able to make sense of them... Maybe there is hope?!

Mike

[bakes]

It's funny because this cal was awful on the old motor i think mostly because of the motor heath but on this new power plant it is beautiful i just want to add some features and add the nos retard to the car.

[ShelGame]

Looks like an older Paul Veliky cal (his signature is in there with the year 2005). I think before he was working with TU? Anyway, it looks like it's based on the A069 T2 binary. My A553 (Mopar Performance) .tbl seems to work fine with it once I cut it down to the original 16k (the file you posted above is 32k, but the first 16k is all 00's).

[bakes]

Thanks Rob your the man once again !!!! I looked at the fueling and because Pumping is not the same the fuel tables are different . but i can use the timing talbes .

[zin]

once I cut it down to the original 16k (the file you posted above is 32k, but the first 16k is all 00's).

Is this another way of setting the off-set? Just zero out the first 16K to have it end at the right spot?

Mike

[ShelGame]

Yeah, you can do it that way. Basically, the actual .bin file needs to be at the end of the full 64k 6811 address space. You can either put the binary there using your burner software, or make the file bigger manually with a hex editor.