PDA

View Full Version : For Sale: 1989 Dodge Daytona Shelby



tryingbe
02-28-2011, 08:29 PM
sold!!!


1989 Dodge Daytona Shelby Turbo TII

I have a white 1989 Dodge Daytona Shelby with T-tops for sell. The car is originally from CA, it's been in AZ last 6 years. Current AZ registration and driven daily. Clean title in hand.

The car's spec is as follow.

Engine
2.5L shortblock (90k or so) with cross-drilled swirl head
Mopar headgasket with Mopar headbolts
New gaskets and seals installed for the longblock
FWD performance stage 2 camshaft
Rebuilt Garrett TII with big can actuator and 2.5 inch swingvalve.
1987 2 piece intake manifold
Slightly ported exhaust manifold
Front mount aftermarket intercooler
BOSCH BOV
3 bar map sensor
All polybusing.com engine mounts

Exhaust
Custom 3 inch downpipe to 3 inch y pipe

Fuel
Flex Fuel Injectors (20% bigger than stock)
255 high flow Walbro fuel pump (20k or so)

Suspension (20k or so)
Ei-Bach springs
Koni strut and shocks
Spicer strut mount bearing
Spicer HD ball joint
Spicer HD tie rod
Polybushings.com front sway bar bushings
All polybushing mounts bushings for the rear suspension
16 inch pumpers wheels with all 4 CS center caps

Brake
Bendix pads up front and rear
SS brake lines

Transmission
A555 transmission with aftermarket bearing support plate
Blak Trax limited slip differential by omnipotentparts.com
Turbosunleashed.com Organic/Ceramic Clutch, Turbosunleashed.com pressure plate

ECU
Socketed 89 SMEC computer with custom 3 bar calibration

Gauges
Central pods holder
AEM wideband
Autometer boost gauge
Autometer oil pressure gauge

Misc
Aftermarket fan
Headlight control works
H4 Headlight conversion kit installed
Digital Dash

Body
153xxx miles on it, one small dent on the driver side where the fender meets the front bumper, few door dings.

There is a lot of aftermarket parts in this car, and I'm sure I am forgetting some. Everything aftermarket has less than 20000 miles on it. I put a lot of time and effort into this Daytona. It was built with stock, and often time, better than stock replacement parts and with best available suspension parts. The car was built with the intention that it would be a fun and reliable daily driver. I would not hesitate to drive the car across the country.

Looking for around $2500. Not looking for trade. No payments. Please e-mail (amazinghl at yahoo.com) or PM with contact phone number. More pictures of the car can be found here. Index of /tryingbe/forsale/daytona (http://www.thelostartof.net/tryingbe/forsale/daytona/)

turbovanmanČ
02-28-2011, 09:02 PM
Holy shitt that's cheap, good luck on the sale.

roachjuice
02-28-2011, 09:55 PM
nice car. i like the plate lol.

Chris W
03-01-2011, 10:37 PM
Do you have the parts for the A/C?

Chris

tryingbe
03-04-2011, 10:13 PM
Only parts I have is a a/c condenser and a/c compressor. Not sure on their condition.

1bad89
03-07-2011, 11:24 AM
Pm sent

1bad89
03-07-2011, 02:26 PM
Does anyone have a way to get ahold of the seller im trying to contact him asap about the car ???

MNmopar
03-08-2011, 12:42 AM
he's on here all the time so I'm sure he'll see ^ and get back to you.

tryingbe
03-08-2011, 01:39 AM
Contacted.

As long as the post is still open, car is still available.

skitzo_inc
03-11-2011, 02:24 PM
if the sale falls through let me know ASAP.

tryingbe
03-13-2011, 12:36 PM
Available.

Daytona541
03-13-2011, 08:14 PM
I am curious. What are those controls do that are located on the lower portion of the steering wheel?

tryingbe
03-14-2011, 09:04 PM
Used to be a fan switch put in by previous owner. Now it does nothing since I upgraded the fan and reschedule via the computer instead.