PDA

View Full Version : Quick Intake Question



CDNTurboZ
06-23-2006, 12:53 AM
I have a shelby charger, I want to convert it to TII, I have a one piece intake, and a two piece intake, I have heard the two piece interferes with the hood vent drain, will the one piece interfere as well??

steve

BadAssPerformance
06-23-2006, 01:16 AM
It might. But you're in luck! OmniPotent now sells re-pro GLHS vent block off plates! :thumb:

check this out (http://www.turbo-mopar.com/forums/showthread.php?t=2928)

CDNTurboZ
06-23-2006, 10:53 PM
It might. But you're in luck! OmniPotent now sells re-pro GLHS vent block off plates! :thumb:

check this out (http://www.turbo-mopar.com/forums/showthread.php?t=2928)


thanks for the link that will help:thumb: ,

Does anyone know if the one piece will fit without modification???

GLHNSLHT2
06-25-2006, 01:29 AM
the 1 piece does fit without mods but you'll like the way the car runs with the 2 piece better. If you do cut the drain pan off DO NOT BLOCK IT OFF! It lets out tons of heat. It is also a vent for any high pressure under your hood when driving at speed. This high pressure will cause lift. Venting it will help keep the nose on the ground. I've had the pan and the grille completely removed from my GLH for years. Even with over a foot of snow sitting on the hood and down on the intake as it fell through the car fired right up and drove home so no worries about hurting the wiring. They're so filled with di-electric grease they're fine.