View Full Version : G-valve check ball size???
Ok, Ive succeeded in launching the check ball in my grainger across the garage! I should probably be more carefull in the future, but for now I need to find another ball.
Can anyone take their grainger apart and tell me the OD of that ball?
thanks,
clay
TurboGLH
06-19-2006, 07:52 PM
I'll try and pull mine tomorrow, but with my luck I'll probably do the same.
Murphy
06-20-2006, 11:47 AM
looks like 1/4"
well I found a ball bearing that had a 0.34" OD, and fit pretty well. It seems bigger than the "stock" ball, but it fit, and works!
thanks guys!
clay
85_600
06-20-2006, 09:02 PM
Ok, Ive succeeded in launching the check ball in my grainger across the garage!
I just can't stop laughing at this site in my head :lol: :lol:
I know the first words out of my mouth would've been "Oh Sh**":lol:
I just can't stop laughing at this site in my head :lol: :lol:
I know the first words out of my mouth would've been "Oh Sh**":lol:
Hehehehe....... yeah, thats pretty freakin close! ;)
85_600
06-20-2006, 11:53 PM
Hehehehe....... yeah, thats pretty freakin close! ;)
I'm sorry...But in my frame of mine when I read that....it was just too funny.
I once had to hit a set of spring compressors to get them off the springs...The spring went down the driveway about 30' and then the other one hit the back of the garage....Whoa was what I said...
Glad to hear you got it back together again. I opted to buy a Dawes pre built unit - that and a A/F unit just tonight. Should arrive when I'm 3,000 miles away (CA trip to see my sis next week)...
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.