PDA

View Full Version : Turbos/Intercoolers: WTB/WTT: TII Auto Lower IC hose Masi/Lancer


ShelGame
06-11-2010, 03:33 PM
Looking for a T2 Auto lower IC hose from a Masi or Lancer. It has the metal "T" in it for the BOV hose. I can trade my stock T2 lower IC, or buy it outright.
butchsuppe
06-11-2010, 04:19 PM
If all you need is the T, I'll send you one ( if I still have ) for free. I'll go look for it now and get back to you.
ShelGame
06-11-2010, 04:25 PM
Sounds good. How do you install it? I know the one in my T1 lower hose is kind of swaged in there.
butchsuppe
06-11-2010, 04:45 PM
Yea, I still got it. I got one on my car, just cut the stock hose and used hose clamps on it. PM an address and I'll send it to you.
ShelGame
06-11-2010, 08:24 PM
I think I'd rather have the 1-pc hose from an auto car, if I can find one.

I do have a spare T1 hose with the "T" fitting in it. I could cut that out if I really wanted to do it that way. So, don't waste the postage on it for me. Thanks for the offer, though.
Xtrempickup
06-12-2010, 03:17 PM
i have a masi auto TII hose with stock metal T-pipe in it. asking 45$ shipped
ShelGame
06-12-2010, 03:27 PM
I'll send you a PM when I get back from vacataion week after next.
TopDollar69
06-15-2010, 04:07 PM
All the Masi lower hoses I have seen have a metal T in them, and the hose is basicly the same as a TII, it just has a small 2 inch section cut out of it with the metal T in it's place. They are not like the TI J pipe that has the nipple sort of crimped in place for lack of a better way to put it. I'm willing to bet the one Tom has is the same way.
Xtrempickup
06-15-2010, 05:30 PM
stock masi with the 2in section of pipe with nipple on it to go to bov in airbox
ShelGame
06-15-2010, 08:31 PM
Ohhhh, OK. I didn't realize that's how they did it. I assumed it was the same setup as the T1 - a metal pipe staked into the hose. If it's a full metal 'T', I should probably take Buch up on his offer...
Xtrempickup
06-15-2010, 08:41 PM
Full metal T
GLHNSLHT2
06-15-2010, 08:47 PM
yep, they put it right after the 1st bend next to the head.
TopDollar69
06-15-2010, 11:00 PM
I'm also pretty sure the 87 Shelby Lancer did not have a BOV.
butchsuppe
06-16-2010, 10:49 PM
Rob, I got your PM on AOL but for some reason I can't access my PM's on the board here. Send me an address at lylesuppe@aol.com and I'll send you that T.