shelbymonster
06-11-2010, 01:10 PM
i will start my tona project soon and will need some advice for my alky , the engine set-up is:
t2 bottom end
782 with 89 roller cam (casting flash removed)
2 pieces intake matched to head
3 bar set-up with rob custom cal
stock t2 turbo , 2.5 sv
3 inch mendrel exaust
for now i got a devilsown pump with a big nozzle (dont remember the size)
im planning to run about 25-28 peak psi and maybe 20 after ( in car mbc... )
the questions is : witch nozzles should i use for direct port nitrous ? bigger the better ?
do i need to get the nozzles an angle in the lower intake part ?
with my one pieces intake pinging start a 20 psi at wot with 10:1 fuel ratio
t2 bottom end
782 with 89 roller cam (casting flash removed)
2 pieces intake matched to head
3 bar set-up with rob custom cal
stock t2 turbo , 2.5 sv
3 inch mendrel exaust
for now i got a devilsown pump with a big nozzle (dont remember the size)
im planning to run about 25-28 peak psi and maybe 20 after ( in car mbc... )
the questions is : witch nozzles should i use for direct port nitrous ? bigger the better ?
do i need to get the nozzles an angle in the lower intake part ?
with my one pieces intake pinging start a 20 psi at wot with 10:1 fuel ratio