Trans/Bellhousing dust shields

[iTurbo]

Are all the factory 2.2/2.5 trans dust shields that go between the block and bellhousing the same? I'm trying to scrounge up a few sets for some motors I'm building and I'm not sure what the 'right' ones look like. I can't remember if there are different ones for different years, MTX or ATX, common block or non-CB...For what it's worth the motors I'm building are all common block with manual trans.

[Murphy]

I reused mine on the 5 speed swap on my v6. I would think they would all be the same, sine the bolt pattern is the same, nad you can swap any block whit any trans

[iTurbo]

Yeah I don't see why they would be any different, although I could have swore I had an oddball set long ago. I'm not sure if it came from an auto or what. I'll try to post a pic of a set of shields I want to use if I can find them.

[Force Fed Mopar]

I think the MTX and ATX ones are slightly different, but can be interchanged. Could be wrong though.

[TopDollar69]

I've found them all to be pretty much the same. This is from parting cars built between 84-93, ATX, and MTX.

[135sohc]

There all the same p/n for 2.2/2.5 applications.

[135sohc]

There all the same p/n for 2.2/2.5 applications.

I need a set or two myself but if there still available I was going to just get new ones. around $30 for the set last I checked.

[2.216VTurbo]

One is different for sure, TC Masi with the 284 5 spd trans will not interchange when swapping to a 523/568. Couple bolt holes are just a bit off:mad: Prolly could oval them out some and make it work but it seemed to be less work just to swap the tin out so that's what I did.

[iTurbo]

There all the same p/n for 2.2/2.5 applications.

I need a set or two myself but if there still available I was going to just get new ones. around $30 for the set last I checked.

Heck I'll probably just do that if they are still out there. Most of the time I just assume everything is NS1 at this point. I haven't been going to the local dealership lately to check on stuff because the parts lady working there has a hard time finding stuff and told me to go to Year One to buy window regulators for my Lancer.:banghead:

[135sohc]

Give these guys a try.

http://www.trademotion.com/pages/index.cfm?action=viewPage&siteid=214996&pageid=10439

there an allpar (hold the hate mail please) sponsor and seem to have a fairly good reputation over there.

[iTurbo]

Do you have a part number for the shields? I thought I had a set floating around in my garage somewhere but I can't find them. Hopefully they just stamped the # on the part.