mark
05-12-2006, 10:11 AM
i dont know how people got the srt4 ic into an 2 door lbody.
I got mine installed right behind the bumper. it mounded perfectly. I knew it was too good to be true, I got one side piped with no problem, But...
the side by the alt(side points down) I overlooked that there is a pulley that goes there and the way i wanted to run the pipe will cause clearance problems.
can anyone take some detailed pics of how they overcame this feat. I am just frustated at this point and ready to pull the whole front end off and remove the srt4 and put a same side in and out ic in the car.
thanks in advanced for the detailed pics.
I was thinking of removing the charcoal cannister and relocating it and having it get into the engine compartment form the down spout that way. pro/cons?
thanks!
-Mark
I got mine installed right behind the bumper. it mounded perfectly. I knew it was too good to be true, I got one side piped with no problem, But...
the side by the alt(side points down) I overlooked that there is a pulley that goes there and the way i wanted to run the pipe will cause clearance problems.
can anyone take some detailed pics of how they overcame this feat. I am just frustated at this point and ready to pull the whole front end off and remove the srt4 and put a same side in and out ic in the car.
thanks in advanced for the detailed pics.
I was thinking of removing the charcoal cannister and relocating it and having it get into the engine compartment form the down spout that way. pro/cons?
thanks!
-Mark