69viper
09-16-2009, 02:10 AM
I wired up an inline Walbro fuel pump using the signal wire that goes to the stock pump. The problem is this wire only has just over 8 volts and won't switch the relay that I'm using for the inline pump. I checked the voltage at the factory relay and it is only 8.9 volts. I'm a little bit baffled on why the voltages are so low. (would't be the first time though) What other wire can I use that will have good voltage with the ignition on? The car is a 89 Lebaron.
Thanks,
Steve
Thanks,
Steve