View Full Version : Trying to make a new cal, won't load template I select!
turbovanmanČ
09-09-2009, 03:11 AM
I unzip a new Tsmec cal, do the dos batch file, go into the asm file, paste in the template I want, the MP 6343H and I get the A131H cal, :banghead: I've tried it numerous ways but it still comes up as A131H?
ShelGame
09-09-2009, 09:00 AM
Change the .asm first, then run the batch.
DodgeZ
09-09-2009, 09:15 AM
Change the .asm first, then run the batch.
http://boostedmopar.com/temp/roflcopter.gif
turbovanmanČ
09-09-2009, 08:36 PM
Change the .asm first, then run the batch.
I think I tried that too and it didn't work, I'll try it again.
http://boostedmopar.com/temp/roflcopter.gif
What's so funny????????? :confused::confused::confused:
Oh right, I forgot, you NEVER forget things, :banghead:
DodgeZ
09-09-2009, 10:49 PM
I think I tried that too and it didn't work, I'll try it again.
What's so funny????????? :confused::confused::confused:
Oh right, I forgot, you NEVER forget things, :banghead:
You have no clue what is going on that is what is so funny. Let me put this in car terms....
"So I filled up my motor with oil. Then I put the drain plug in. I don't understand why there is oil all over the floor. :banghead: I've tried it numerous ways but it still ends up with oil all over the floor."
Now tell me would you laugh if someone posted that?
turbovanmanČ
09-09-2009, 11:17 PM
You have no clue what is going on that is what is so funny. Let me put this in car terms....
I have no clue??????? :confused::confused::confused::confused::confused: :confused::confused:
GLHNSLHT2
09-10-2009, 12:07 AM
DodgeZ needs to lay off the crack pipe a bit.
turbovanmanČ
09-10-2009, 03:06 AM
DodgeZ needs to lay off the crack pipe a bit.
He's way to far gone for that. :o
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.