PDA

View Full Version : Switch from 2bar to 3bar question ASAP



Rattlesnake
05-04-2006, 10:43 PM
Hi guys, I just installed my new cal on my car with the 3bar map sensor. I had a code for map signal not changing. My question is: When you switch from 2 to 3bar sensor, do you just connect the plug or you have to arrange the wiring on the plug before you connect it to the sensor?
Need asap, going to track tomorrow.

Thanks

altered7151
05-04-2006, 11:21 PM
You have to notch one of the terminals on the plug side so that it fits into the map sensor properly. Maybe you have it plugged in the wrong way?

Rattlesnake
05-05-2006, 07:19 AM
You have to notch one of the terminals on the plug side so that it fits into the map sensor properly. Maybe you have it plugged in the wrong way?
Already did that 2 years ago when I had a Super60 cal. Do you have to rotate the connector?

GLHSKEN
05-05-2006, 07:35 AM
No just notch and go.

Rattlesnake
05-05-2006, 09:14 AM
No just notch and go.
Thanks Ken:thumb: