View Full Version : P/S pump pulley
87glhs232
04-26-2006, 07:36 PM
How do you guys get yours off....and back on? I really don't want to buy every special tool the FSM mentions. Thanks!
tryingbe
04-26-2006, 09:08 PM
Go to autozone and rent a tool.
87glhs232
04-26-2006, 10:20 PM
I did.
Tomorrow I'll bead blast and paint the pulley (as well as the other pulleys).
She's starting to look good :thumb:
BadAssPerformance
04-26-2006, 10:23 PM
If you have the correct tool, its a snap unless it is rusted onto the shaft (Can that happen in So Cal?). If thats the case, load it up with some PB Blaster...
87glhs232
04-27-2006, 12:23 AM
It came right of with the proper tool....no problem.
And no...not much rust around here. Unless it's imported from the midwest!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.