looking for a pull-up ring for an 88 Daytona C/S.

[MAturboCS]

Does anyone have/or know where I can get that stupid piece of plastic pull-up ring for an 88 Daytona? I've had my car for a week, and now it doesn't go in reverse because the pull-up ring detached from the cable. I am contemplating jury-rigging it with a screw/piece of wire or something, but would rather just replace the ring. Anyone have one/know where I can get one??

[bfarroo]

If it's the white plastic piece the dealership had them last time I needed one.

[blk86trbo]

I'm copying and pasting this info, but I believe it's the correct part numbers

Shifter pull ring - 04443404
Shifter knob - 04431264
Shifter retainer and decal - 04295345

[Tony Fields]

Does anyone have/or know where I can get that stupid piece of plastic pull-up ring for an 88 Daytona? I've had my car for a week, and now it doesn't go in reverse because the pull-up ring detached from the cable. I am contemplating jury-rigging it with a screw/piece of wire or something, but would rather just replace the ring. Anyone have one/know where I can get one??


Here's a thread on a good repair for your problem:
It worked for me

http://www.turbo-mopar.com/forums/showthread.php?t=16089

[martin kolner]

4443404 is the pin,strap,and ring pkg. 1987-89. I have them NOS if they are discontinued.

[MAturboCS]

Thanks for the part #s and the link. I did order the part, but wound up jury rigging it. That thread was a big help, and what I ended up doing was drilling a hole through the ring near the top, and through the plastic, and stuck a paper clip through the hole, around the back of the white plastic, and looped it through the small hole at the top of the white plastic. Works fine now. My mechanic told me I was better off doing it this way for now, and at least I'll have the part just in case. Thanks to all for your help!