Code 43 twice??

[30 PSI SHADOW]

My rampage T3 is skipping, bumbling, checked codes and got 53,13,43,43 ...twice??

Any insight??

[contraption22]

It REALLY means that code 43.

I'm guessing since the TIII has two ignition coil circuits, that must be why it's reading twice.

Fault Code 43.
Synopsis
Description: Ignition coil driver circuit open or shorted.
Power loss light: Off
Limp-in mode: None

Possible Causes
Bad connection or wiring - Check the wiring and connections between the ignition coil and the power module (or SMEC). Clean and regrease any corroded connectors with dielectric grease and repair any shorts.
Ignition coil driver transistor failure - Replace the power module (or SMEC).

Ignition coil failure - Using an ohmmeter, measure the resistance of the primary ignition coil between the two small stud on the top of the coil. It should measure about 0 ohms.


Diagnostic Method
Trigger Parameters
- Near 0V or near 12V not detected when the coil is turned on or off, respectively
Results If Component Fails
Fault code 43 is stored and the engine will stall.


Fault Code 53
Synopsis
Description: Internal logic module fault
Power loss light: Off
Limp-in mode: None

Possible Causes
Bad connection or wiring - Check the wiring and connections between the logic module and the power module. Make sure the logic module is getting all of its power feeds and that it is properly grounded (through the ground lug at the fuel rail). Clean and regrease any corroded connectors with dielectric grease and repair any shorts.
Logic module or SMEC failure - Replace the module.


Diagnostic Method
Trigger Parameters
- Logic module failed an internal diagnostic
Results If Component Fails
Fault code 53 is stored.

[30 PSI SHADOW]

interesting... could that mean my computer has a ignition driver failure??