View Full Version : wiesco piston with some pits in it
Mr overkill
04-24-2009, 11:26 PM
ok so it looks like #3 spark plug puked the porclin and dented/pitted up the piston i sanded it nice and flat and all but still has the dings in it. Is it fine and throw it n or garbage???
Warren Stramer
04-25-2009, 12:06 AM
Would need to see a good clear close up pic.
Directconnection
04-25-2009, 01:28 AM
Dings on top should be ok..... I have seen some scary sheet come through the shop over these past few years. But, a pic would be helpful.
Juggy
04-25-2009, 02:27 AM
id gamble yuor good 2 go, but without pics we cannot guarantee anything. i would think as long as it didnt get jammed between the piston/ring and the wall, your safe.
how does the cylinder wall look? scored at all??
turbovanmanČ
04-25-2009, 03:09 AM
If just the top, run it. We did this with 2 strokes all the time, :thumb:
Mr overkill
04-25-2009, 08:31 AM
yea its just the top the sidewall and all are fine i will post a pic or 2 after i get back from the garage
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.