View Full Version : Chris! Help needed !
turboaddict
03-31-2009, 02:10 AM
i have a tu ss header that i have been trying to install. can you help a brotha out? refer to this thread:
http://www.turbo-mopar.com/forums/showthread.php?t=35322
thanks in advance
turbo84voyager
03-31-2009, 10:17 AM
I never had to do any modfications to mine. I highly recomend using a felpro gasket and go to fastenal and get a set of top lock nuts. The factory nuts worked their way loose in 3K miles on mine.
Chris W
03-31-2009, 12:08 PM
i have a tu ss header that i have been trying to install. can you help a brotha out? refer to this thread:
http://www.turbo-mopar.com/forums/showthread.php?t=35322
thanks in advance
What's your name and when did you purchase it from us?
Chris-TU
turboaddict
03-31-2009, 10:40 PM
http://www.turbododge.com/forums/f7/f28/117933-sale-turbos-unleashed-header.html
purchased nib in this thread, if needed i can locate original buyers name. at time of purchase i contacted you to make sure that it was sold to him.
Juggy
03-31-2009, 10:53 PM
I never had to do any modfications to mine. I highly recomend using a felpro gasket and go to fastenal and get a set of top lock nuts. The factory nuts worked their way loose in 3K miles on mine.
the factory nuts are the locking ones
black86glhs
03-31-2009, 11:40 PM
What if you have the intake manifold flange resurfaced so the manifold tilts up away from the turbo a little? That would take care of the clearance issues. I'm talking about a slight angle.
bradp
03-31-2009, 11:44 PM
http://www.turbododge.com/forums/f7/f28/117933-sale-turbos-unleashed-header.html
purchased nib in this thread, if needed i can locate original buyers name. at time of purchase i contacted you to make sure that it was sold to him.
Chris can't & won't go to TD.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.