85_600
04-14-2006, 06:27 PM
In order to keep my minor rebuild on my engine as simple as can be, I'd like to make the adjustments needed to the tranny before hand. I don't drive my 600 much, if hardly at all, so this may not be an issue.
What I've been told by several people, including Cliff and Simon, is, after my T2 conversion, is to raise the line pressure a bit and a adjust the bands on my 413.
Would doing this and driving the car before the conversion have any negative side effects on the tranny? Remeber: Basically the 600 is stored at my fathers house until I can work on it. It only gets driven when I go to see it.
Thanks!
Paul
What I've been told by several people, including Cliff and Simon, is, after my T2 conversion, is to raise the line pressure a bit and a adjust the bands on my 413.
Would doing this and driving the car before the conversion have any negative side effects on the tranny? Remeber: Basically the 600 is stored at my fathers house until I can work on it. It only gets driven when I go to see it.
Thanks!
Paul