Turbo Guru's Come in..

[SpoolinGLH]

I just recieved my new t3/t4 turbo from turbonetics and before i install this bad boy i want to make sure its right.. I ordered a super50 trim but there was some difficulty getting it and i told them to send me a 50 trim... but when i got it it said s50 on the box.... so if i take pictures tonight will you guys be able to determine exactly what it is?? Also how do i tell that there is a st2 turbine housing and wheel??

[turbovanman²]

Take the measurements of the inducer and exducer, then Frank or turbo guru's can tell you what they mean. In English, measure the largest part of the wheel and then where they start to neck down.

[TurboMinivan]

I ordered a super50 trim but there was some difficulty getting it and i told them to send me a 50 trim... but when i got it it said s50 on the box.... so if i take pictures tonight will you guys be able to determine exactly what it is??

Yes, be sure to measure the inducer and exducer--that will tell you what you have. For reference, both the standard 50 and the Super50 have an inducer measurement of 2.122". On the exducer, the standard 50 measures 3.00" while the Super60 is 3.20". HTH

-Dempsey

[SpoolinGLH]

cool thanks guys....