PDA

View Full Version : Fitting with steel line for Accufab AFPR



Xtrempickup
03-22-2006, 05:04 PM
I havent had any luck getting a fitting to screw into the base of my AFPR that i bought so i can hook it up on my car. can anybody help me out?? anybody know where they can buy one and can get it for me and i can pay you for it and you can send it to me??? i can't get anything for it

89DaytonaTII
03-22-2006, 05:50 PM
I'm assuming you mean a universal regulator, if that's the case TU has those fittings.

turbovanmanČ
03-22-2006, 06:40 PM
Go to the GM wrecker, find any TBI car, take the feed or return line, can't remember which one. There a perfect fit and actually better than the Dodge line as these are GN reg's.

Xtrempickup
03-22-2006, 07:27 PM
ok, I guess i will have to take a look at a few GMs and see if I can find one

Clay
03-22-2006, 07:45 PM
or, any industrial supply type place should have the correct fitting in stock.

clay

Xtrempickup
03-22-2006, 08:15 PM
i was to a brass supply place today and had it with me and he had no idea what thread it was. i just want to get it on my car. i guess i gotta schedule time to the junkyard to find a used line off a gm. where abouts is one of these on a GM?

turbovanmanČ
03-22-2006, 08:53 PM
i was to a brass supply place today and had it with me and he had no idea what thread it was. i just want to get it on my car. i guess i gotta schedule time to the junkyard to find a used line off a gm. where abouts is one of these on a GM?

Where it goes into the throttle body, you will need a small tube cutter, 16mm and 3/4 inch wrenches.

Xtrempickup
03-22-2006, 10:04 PM
thanks, i guess thats the next trip