PDA

View Full Version : General: Miscellaneous 12 valve, 24 valve 3.0L engine parts and dodge neon parts



dodgeshadowchik
09-08-2008, 09:56 PM
Rebuilt 3.0L 12V engine with about 1000miles. New rings, bearings, gaskets, water pump, timing belt, oil pump, ect… The heads were sent out and redone.. New valve stem seals and such. The block was hot tanked. All Mitsubishi parts were used, except for the gasket kit, which was felpro. (Note exhaust manifolds not included) Asking $400

The trans is an A543. Was told it’s the 3.77 ratio. Not sure of mileage, but it shifted great when it was in the car. Comes with center force clutch $280

Partial turbo setup that comes with the front exhaust manifold, crossover pipe and rear exhaust manifold made by Ed Kelley. Also comes with 6 t2 injectors, upper intake plenum,stock throttle body,and oil pan. The turbo is from a ford I bought rebuilt, but I do not know who rebuilt it . It has a .60 A/R on the compressor side and the .48 on the exhaust. I know that small, but I needed the Chrysler housing. No in/out shaft play, very little side/side. Comes with miscellaneous hoses, fittings, and tubes. $300 for all of it. At this time I will not separate


P-Body cruise servos , cable and vacuum box $15 each

P-Body rear tail lamps $20

1 P205/50R15 Falken tire almost new $10


3.0L SOHC 12V Engine

Cylinder heads need redone. $35

Distributor $35

Underdrive pulley and belt $55

Power steering pump $30




Neon parts

Neon new mopar a/c condense, receiver/drier and evaporator coil $260 for it all

Neon trunk lid w/spoiler green a few dents rust free $50

Neon air bags $30

Neon wiper motor $15

Neon HVAC controls $15 w/cables $10 w/out cables

Neon gas door white $10

Neon grill insert white $10

Neon ldp pump, purge valve, and evap canisters $20

Thanks for looking !!

pics: (I do have more...)
http://i12.photobucket.com/albums/a206/dodgeshadowchik/threeptoh/DSC_0028.jpg
http://i12.photobucket.com/albums/a206/dodgeshadowchik/threeptoh/DSC_0071.jpg
http://i12.photobucket.com/albums/a206/dodgeshadowchik/threeptoh/DSC_0074.jpg
http://i12.photobucket.com/albums/a206/dodgeshadowchik/threeptoh/DSC_0077.jpg
http://i12.photobucket.com/albums/a206/dodgeshadowchik/threeptoh/DSC_0100.jpg
http://i12.photobucket.com/albums/a206/dodgeshadowchik/threeptoh/DSC_0112.jpg
http://i12.photobucket.com/albums/a206/dodgeshadowchik/threeptoh/DSC_0110.jpg

black86glhs
09-08-2008, 10:33 PM
Typical woman......er....I mean......lots of great stuff!!!:evil:

jaysshelby
09-08-2008, 10:38 PM
can i see a pic of the surf board spoiler?

dodgeshadowchik
09-08-2008, 10:41 PM
Typical woman......er....I mean......lots of great stuff!!!:evil:
:lol:

yea well... you kno! :p

dodgeshadowchik
09-08-2008, 10:45 PM
can i see a pic of the surf board spoiler?
sure thing!
http://i12.photobucket.com/albums/a206/dodgeshadowchik/P1010013-1.jpg

http://i12.photobucket.com/albums/a206/dodgeshadowchik/P1010014-1.jpg

jaysshelby
09-08-2008, 10:59 PM
if you can bring it to Norwalk this weekend I will take it.

turbovanman²
09-09-2008, 12:27 AM
Wow, screaming deal on the turbo setup, :nod:

dodgeshadowchik
09-09-2008, 08:12 AM
if you can bring it to Norwalk this weekend I will take it.

allrighty! i shall bring it along! thanks!

Force Fed Mopar
09-09-2008, 11:28 AM
Why are the V6 trannies always so far away? :(

black86glhs
09-09-2008, 03:21 PM
:lol:

yea well... you kno! :p
You know I love ya!!!!:blah:
Makes me wish I had a 3.0.:love:

Reaper1
09-09-2008, 04:36 PM
*snifff-sniff* She doesn't love the 3.0 anymore :( I'm sad! LOL

Wish I had $300 right now...it'd take that turbo stuff off your hands in a heartbeat!!

dodgeshadowchik
09-09-2008, 06:46 PM
you guys are funny. :) and you kno i love you all, too! :love:

reaper1, i still like the 3.0L... i've just been converted to the "dark side" of the 16v way of life.

Reaper1
09-10-2008, 11:19 AM
It's all good...we still love you! :love:

BadAssPerformance
09-10-2008, 11:21 AM
you guys are funny. :) and you kno i love you all, too! :love:

reaper1, i still like the 3.0L... i've just been converted to the "dark side" of the 16v way of life.

[Mr._Burns_Voice] My plan is working... Exxxcellent! [/Mr._Burns_Voice]

:D

Reaper1
09-10-2008, 05:36 PM
[Homer_Simpson's_Voice] DOH!! Now how am I supposed to pay for that? [Homer_Simpson's_Voice]

:D

fgp87
09-13-2008, 10:32 PM
I would love to pick up the engine, but don't have funds for that right now. If I get some extra cash will check with you later to see if you still have engine. fgp87

dodgeshadowchik
09-23-2008, 06:03 PM
sold the:
-vr4 crank and 24V rods/pistons
-rear shocks
-window scrapers.

dodgeshadowchik
10-09-2008, 07:55 PM
:bump2: