PDA

View Full Version : main studs and head studs



Murphy
03-18-2006, 10:12 PM
ok so im installing ARP main studs and head studs. so after i clean out the holes, and coat the studs with assembly lube, I only put the studs in finger tight? then they get torqued down then I install the main caps or the head? for the main caps should i torque them down without any bearings in them befroe i take it to the machine shop to check for roundness?

Thank You

Murphy
03-18-2006, 11:00 PM
and is there soposed to be any type of gasket between the block and the oil pump?