PDA

View Full Version : DOHC hardware parts needed.



dds78910
08-14-2008, 09:59 AM
Just looking for a place that sells some misc. parts for the DOHC neon heads. Parts like valve cover bolts and gaskets, intake and exhaust manifold bolts. Things like that. Is there a good place to get those things?

rbryant
08-14-2008, 02:12 PM
I have some of that stuff on my DOHC conversion page:
(http://rbryant.freeshell.org/dohc_conversion_products.htm)
Stainless VC bolts
Stainless Intake Mani bolts

I think the prices are reasonable and much cheaper than buying them individually or getting them in bulk like I did where you only use a few and have no need for the rest...


Exhaust mani bolts are probably best left stock since they get a lot more heat and should be 10.9 or better bolts. The intake is less critical so stainless can be used in place of the stronger alloy bolts.

The VC gasket is reusable on my PT engine and I assume all of the 2.0/2.4 VC gaskets are.

I also have some PT and 2.7 rockers in the garage sale section if you are looking to upgrade the valvetrain.

-Rich