QKsilverF1
03-16-2006, 11:23 AM
Ok, i pulled my trans today to replace the clutch because my relentless stage 2 clutch was slipping after about 2 years and about 10-15k miles. i went with a Spec stage 3+ clutch. So I pull the axles and notice that not that much fluid is coming out. I only collected about this much see link below for picture
http://community.webshots.com/photo/...63423720hQbNho
Is this a normal amount? seems low.
anyways i finally get the trans off and notice a TON of oil/silver gunk in the bellhousing. could this be due to tranny fluid leaking? see pictures (remember this was all cleaned out 2 years/15k miles ago when my cousin and I did the clutch.)
http://community.webshots.com/photo/...63423720NFRyAu click "view full size" to get a good view of it)
http://community.webshots.com/photo/...63423720SFTZLD click "view full size" to get a good view of it)
and here is a close up of the Throw out bearing and the silver oily substance
http://community.webshots.com/photo/...63423720CaILbr
(again you can do the view full size thing if the picture isnt big enough to see detail, these pictures are all 7.2mp when you click view full size)
If you look at the input shaft you can see some of the gunk pretty well
I also noticed that my throw out bearing seemed to be releasing wierd check this video of it out, it seems to twist at the very bottom of the cluch stroke
(dialup beware, its 35mb but a pretty High quality video)
http://s50.yousendit.com/d.aspx?id=2XRQ7KEZIDWA520ELL4T1OGNXO
So to all the experts out there give me your take on what im dealing with here. this is my frist time removing the trans/changing the cluth by myself (and second total) so im pretty clueless about transmissions.
http://community.webshots.com/photo/...63423720hQbNho
Is this a normal amount? seems low.
anyways i finally get the trans off and notice a TON of oil/silver gunk in the bellhousing. could this be due to tranny fluid leaking? see pictures (remember this was all cleaned out 2 years/15k miles ago when my cousin and I did the clutch.)
http://community.webshots.com/photo/...63423720NFRyAu click "view full size" to get a good view of it)
http://community.webshots.com/photo/...63423720SFTZLD click "view full size" to get a good view of it)
and here is a close up of the Throw out bearing and the silver oily substance
http://community.webshots.com/photo/...63423720CaILbr
(again you can do the view full size thing if the picture isnt big enough to see detail, these pictures are all 7.2mp when you click view full size)
If you look at the input shaft you can see some of the gunk pretty well
I also noticed that my throw out bearing seemed to be releasing wierd check this video of it out, it seems to twist at the very bottom of the cluch stroke
(dialup beware, its 35mb but a pretty High quality video)
http://s50.yousendit.com/d.aspx?id=2XRQ7KEZIDWA520ELL4T1OGNXO
So to all the experts out there give me your take on what im dealing with here. this is my frist time removing the trans/changing the cluth by myself (and second total) so im pretty clueless about transmissions.