Nemesismachine
07-28-2008, 01:26 PM
I was looking a while ago for rails for a set of Ultra Shield/Kirkey brackets for an L body. Upon some investigation, the stock brackers are curved (convex) to the floor pan. This sucked, because the seat bottoms are flat. Rather than spacers or fab up some goofy wedge to hold the rears up, I just bought a set of universal dual locking seat sliders from summit.
I drilled out the rivets for the stock sliders, took a few measurements, and welded in a piece of 1/8" steel on top of the stock slider mounts. perfect width, and flat enough for the seat not to warp. I will have pics up later tonight when the chassis black dries on the brackets a little better. :)
I drilled out the rivets for the stock sliders, took a few measurements, and welded in a piece of 1/8" steel on top of the stock slider mounts. perfect width, and flat enough for the seat not to warp. I will have pics up later tonight when the chassis black dries on the brackets a little better. :)