T-III spark plugs?

[Bardo]

what are you using? I'm looking for a plug that most people like to use so i can cross reference it to E3 and see if there any better

[BadAssPerformance]

I added "T-III" to your title. I was going to say RN9YC until I read your sig ;)

[Bardo]

thanks jt. i looked on E3's page for something like the rn9yc but didnt find anything. i though if i could find them that would give me a good starting point

[BadAssPerformance]

No problemo. :thumb:

Maybe list out all your mods? Most times on a modded turbo motor, it is pretty safe to go with one plug heat range colder than stock.

[Bardo]

well right now its mostly stock. i have a 3" with cat only on it, im looking to go to the track this week and i wanted to turn the boost up to about 17 and run some 110 in her. i was looking to find out that people were running so i could go 1 or 2 steps cooler

[Blue Iroc R/T]

I'm running Autolite 63 in my R/T

[Bardo]

I'm running Autolite 63 in my R/T

what kind of mods and boost? this is a start :)

[Bardo]

ok i got it. the 368-E3.46 would be something like the autolites 63
EDIT
these plugs are also a replacement for the N9YC N11YC and N12YC

[Will Martin]

Autolite 63's.

[Xtrempickup]

i have NGK BR9ES gapped at .028 in my car that pumped out the 408WHP and 442ft lbs of trq. im running 27psi and meth/water injection

[Blue Iroc R/T]

what kind of mods and boost? this is a start :)

It's hard to NOT call mine Stock, BUT the few Mods are;
Ti Retainers, K&N filter, JoeP MBC, 13psi., 8.5mm magnacore Wires, Harland Shift Light (Set at 6,000), Booger Bushing, Poly Bushings Motor Mounts (front, Pass and Tranny).

But the big choker is the Original Exhaust (yes original with 92k).