2.4 Gbody pass mount Question

[glhs502]

My setup is sitting too high on the pass side. I have a 2.4 Neon swap adapter from Modern Performance, a 1st Gen Neon rubber mount and a 97 Status bottom mount. What am I missing or not doing right??

[t3rse]

do you have all the mounts hooked up? if it laying too far back it will be higher.

[Speedeuphoria]

I had to flip my stock mount upside down and Not use the stock spacers to get it to sit level. This is with the neons adapter.

Or you can do what the innovator him self did(speaking of Rob)
http://www.turbo-mopar.com/forums/showthread.php?t=18097

[glhs502]

Update--I took a stock 1st Gen Neon mount, turned the rubber inside the mount upside down then took the complete mount and installed it upside down. The engine now sits much better in the engine bay. I still need to do some grinding on the Neon mount but this will work.
Also for my front mount I used a complete 99 Caravan front mount. All I had to do was open up the 3 bolt holes that attach to the core support so the mount would move to the passenger side about 1/2 inch.