Moparbishi
03-08-2006, 03:04 AM
wel after rebuilding the lower end i dropped the motor back in. i put on a gerret t2 and ss lines and stuff. On the way to break it in the turbo let it self go and oil and smoke filled everywhere. i get it to my freinds house and i have code 13 for the map sensor and code 43 for ignition driver.
today we took the gerrett off and put back on the mitsu with out pulling the head . car boosts now but ruuns like ----. idles good but under acceleration it bucks real bad. code 43 and 13 are still there and when i give it gas it feels like it is misfireing real bad. the air fuel says lean. any sugeestions on where to go.
oh also i changed the map sensor, and i tried bypassing the baremetric selinoid and it made it run better. but still bad.
today we took the gerrett off and put back on the mitsu with out pulling the head . car boosts now but ruuns like ----. idles good but under acceleration it bucks real bad. code 43 and 13 are still there and when i give it gas it feels like it is misfireing real bad. the air fuel says lean. any sugeestions on where to go.
oh also i changed the map sensor, and i tried bypassing the baremetric selinoid and it made it run better. but still bad.