Parts assortment

[tps25pentium]

http://www.darksideracing.net/gallery/albums/userpics/10002/autoparts.jpg

Location: Indiana
Policy: Prices do not include shipping. PayPal or money order.

ELECTRICAL
86GLH LM $30.00
plug wires (magnacore 8.5mm, the coil-dist wire is bad so I included a new shorter Taylor 8mm wire with a different connector) $25.00

ENGINE (NON-CB) PARTS
belt, alternator (dayco, almost new) $5.00
belt, timing (new) $10.00
bracket, alternator tensioner $10.00
bracket, alternator/compressor $10.00
bracket, intermediate axle shaft $10.00
bracket, starter support $5.00
distributor $15.00
housing, crank seal, frt $5.00
housing, crank seal, rear $5.00
housing, intermediate shaft seal $5.00
int shaft $30.00
oil pan $15.00
pulley, crank 4 bolt $10.00
pulley, water pump $5.00
sprocket, int shaft square tooth $10.00
water pump housing $15.00

OTHER PARTS
sprocket, cam square tooth $5.00
throttle body $10.00
cable, clutch $5.00
cable, accelerator $5.00
bracket, transmission shifter cable $5.00
injectors, stock TII $20.00
lifters, roller (8) $15.00
compressor tensioner pulley $5.00
slider cam (told it was S60 but can't verify) $20.00
stock exhaust manifold $20.00

TURBO PARTS
garrett turbocharger (fresh rebuild from a TD vendor) $350.00
wastegate, small can $20.00
2.25” sv housing (3) $10.00
.48 a/r turbo housing $10.00

COMMON BLOCK PARTS
common block main bearing caps (wrapped in white bag) $20.00
cb crank timing sprocket (new, Mopar) $15.00
cb timing tensioner (new, Mopar) $30.00

PARTS NOT SHOWN:
non-cb 2.2L crank (lightweight, not forged) $30
heavy duty TII rods (set of 4) $50

[moparzrule]

Does the .48 housing have any bolts broken off in it? Also does the distributor have any play in the shutter wheel or any play anywhere else?

Oh and are any of your 2.25'' swingvalves the large flange 88' style? All for garrett correct?

[grim]

can u pm me the price shipped to 25401 w.v for the magnacore wires .

thanks
billy