inplansight
04-29-2008, 06:14 PM
I did not see an area for this quiestion so I thought I would post it here. I am trying to install an balupunkt velocity Vc540 and am not sure how to wire up the tweeter speakers there are two crossovers ? I think that came in the kit but no paper work.
I was looking at it and under the cover there are six screws for wires and two switchs. The screws from left to right read as
+ in - (space) + WF - (space) +TW -
The set of the left is the input but the other two I am not sure about?
The two swithces read tw/3khz (left) freq/6khz (right) The other reads TW/ -3db (left) gain/0db right.
Now the kit had three groups of wires one yellow the second green and the third red and black toghter (same pull)
I am not sure what to wire where and switch which way?
Thanks paul B
http://www.blaupunkt.com/us/7606200260_main.asp
I was looking at it and under the cover there are six screws for wires and two switchs. The screws from left to right read as
+ in - (space) + WF - (space) +TW -
The set of the left is the input but the other two I am not sure about?
The two swithces read tw/3khz (left) freq/6khz (right) The other reads TW/ -3db (left) gain/0db right.
Now the kit had three groups of wires one yellow the second green and the third red and black toghter (same pull)
I am not sure what to wire where and switch which way?
Thanks paul B
http://www.blaupunkt.com/us/7606200260_main.asp