Clay
02-23-2008, 12:41 PM
How do you make the switchable / selectable boost work?
I guess this is a two part question.
I. With Rob's 'turbonator' cal, it has the option of selectable boost. To make this functional, is all you have to do is check the box in dcal or chem? Im guessing this is yes.
II. Once it is functional..... how to you activate it? ie apply voltage to a pin on the LM? ground out a pin in the LM? something else?
thanks,
clay
I guess this is a two part question.
I. With Rob's 'turbonator' cal, it has the option of selectable boost. To make this functional, is all you have to do is check the box in dcal or chem? Im guessing this is yes.
II. Once it is functional..... how to you activate it? ie apply voltage to a pin on the LM? ground out a pin in the LM? something else?
thanks,
clay