cams1021
12-14-2007, 06:03 PM
Car is located in Yarmouth Port Mass. 02675
This is a 87 Shadow ES 2 Door with sunroof. Car had all power options. Approx 112k miles. It is an original turbo car.
It is completely rust free and would be a good donor shell. Car has a clean PA title, never registered in ma.
I was going to build a track-only drag car, but have lost interest/time and want to get out of TDs.
The car was my school (Wyotech) project and I put in a 1-3/4" .120 wall HREW tubing 8 point cage. The cage is tied to the body on 6"x6" 1/8" thick floor plates. The floor plate welds have been seam-sealed.
I also boxed the rear axle, built an adjustable tubular rear panhard bar, boxed the rear panhard bar bracket. I also built a 7/8" .150" wall DOM rear swaybar. It comes with the bushings, and adjustable end links. A stock gas tank will not fit in this vehicle unless the crossmember for the swaybar end link mounts is removed.
Not pictured but included:
Engine bay harness with logic and power modules.
Rear sway bar, panhard bar and end links.
Brown seats front and rear.
Grey dashboard and various interior parts
Cast front lower control arms
Spare hatch spoiler
Hatch hinges (the ones on it are bent along with the lift shocks)
I have a ton of other spare parts.. $400 buys it all!
The price is $400 firm. The car is sold AS IS
On to the pictures:
http://i12.tinypic.com/8708pyc.jpg
http://i3.tinypic.com/6ob5h7c.jpg
http://i1.tinypic.com/6koozte.jpg
http://i2.tinypic.com/6yd1n53.jpg
http://i4.tinypic.com/6y4g09w.jpg
http://i6.tinypic.com/6numqew.jpg
http://i5.tinypic.com/8bsf9c8.jpg
http://i14.tinypic.com/86inl83.jpg
http://i1.tinypic.com/6k76opl.jpg
http://i15.tinypic.com/81u0gv5.jpg
http://i11.tinypic.com/8gg7doo.jpg
http://i10.tinypic.com/71qez2h.jpg
http://i15.tinypic.com/89twbde.jpg
http://i11.tinypic.com/6lm93c6.jpg
And some included parts:
-2 8 valve turbo valve covers
-88 SMEC
-Socketted 88 SMEC
-Floor plate for shifter
-Rising rate fuel pressure regulator
-Original logic and power modules for this car
-Engine bay harness
-One piece intake throttle body
-Axle and intermediate shaft
-Radiator and turbo inlet hose
-2.5 balance shaft assembly
-2.5 oil pan
-Front and rear seats (brown)
-Original dashboard (grey)
-T2 intercooler
-Cast minivan control arms
-Front bumper turn signal lenses
-2 shadow radio bezels
-3 wire O2 sensor
-sandblasted rear main seal housing with new seal
-SRT-4 injector cover
-various sandblaster engine brackets/tensioners
-sandblasted AC delete bracket
-sandblasted waterpump housing
-spare hatch spoiler
-8 bolt flywheel with crank and PP bolts
-Original gauge cluster
Make an offer! it has to go!
This is a 87 Shadow ES 2 Door with sunroof. Car had all power options. Approx 112k miles. It is an original turbo car.
It is completely rust free and would be a good donor shell. Car has a clean PA title, never registered in ma.
I was going to build a track-only drag car, but have lost interest/time and want to get out of TDs.
The car was my school (Wyotech) project and I put in a 1-3/4" .120 wall HREW tubing 8 point cage. The cage is tied to the body on 6"x6" 1/8" thick floor plates. The floor plate welds have been seam-sealed.
I also boxed the rear axle, built an adjustable tubular rear panhard bar, boxed the rear panhard bar bracket. I also built a 7/8" .150" wall DOM rear swaybar. It comes with the bushings, and adjustable end links. A stock gas tank will not fit in this vehicle unless the crossmember for the swaybar end link mounts is removed.
Not pictured but included:
Engine bay harness with logic and power modules.
Rear sway bar, panhard bar and end links.
Brown seats front and rear.
Grey dashboard and various interior parts
Cast front lower control arms
Spare hatch spoiler
Hatch hinges (the ones on it are bent along with the lift shocks)
I have a ton of other spare parts.. $400 buys it all!
The price is $400 firm. The car is sold AS IS
On to the pictures:
http://i12.tinypic.com/8708pyc.jpg
http://i3.tinypic.com/6ob5h7c.jpg
http://i1.tinypic.com/6koozte.jpg
http://i2.tinypic.com/6yd1n53.jpg
http://i4.tinypic.com/6y4g09w.jpg
http://i6.tinypic.com/6numqew.jpg
http://i5.tinypic.com/8bsf9c8.jpg
http://i14.tinypic.com/86inl83.jpg
http://i1.tinypic.com/6k76opl.jpg
http://i15.tinypic.com/81u0gv5.jpg
http://i11.tinypic.com/8gg7doo.jpg
http://i10.tinypic.com/71qez2h.jpg
http://i15.tinypic.com/89twbde.jpg
http://i11.tinypic.com/6lm93c6.jpg
And some included parts:
-2 8 valve turbo valve covers
-88 SMEC
-Socketted 88 SMEC
-Floor plate for shifter
-Rising rate fuel pressure regulator
-Original logic and power modules for this car
-Engine bay harness
-One piece intake throttle body
-Axle and intermediate shaft
-Radiator and turbo inlet hose
-2.5 balance shaft assembly
-2.5 oil pan
-Front and rear seats (brown)
-Original dashboard (grey)
-T2 intercooler
-Cast minivan control arms
-Front bumper turn signal lenses
-2 shadow radio bezels
-3 wire O2 sensor
-sandblasted rear main seal housing with new seal
-SRT-4 injector cover
-various sandblaster engine brackets/tensioners
-sandblasted AC delete bracket
-sandblasted waterpump housing
-spare hatch spoiler
-8 bolt flywheel with crank and PP bolts
-Original gauge cluster
Make an offer! it has to go!