turbovanmanČ
09-15-2007, 11:20 PM
Ok, so the TIII uses the large passage in the front for its PCV system, I haven't taken the head off my TIII engine so unsure on the other smaller passage next to it. On my 8 valve block, there seperate and connected to the head. So as I was drilling out the larger passage, to put a large 3/8 fitting to run the TIII PCV system, I figured I would connect the smaller one, so out came the trusty die grinder and I carefully ground down the middle between the two passages on the head gasket surface. My idea is to give it more flow.
So, did I just make it worse as in more pressure so maybe oil will now get pushed up or did I do good? Comments and suggestions always welcome, :thumb:
So, did I just make it worse as in more pressure so maybe oil will now get pushed up or did I do good? Comments and suggestions always welcome, :thumb: