View Full Version : 1/4" Turbonetics Threaded Adjustable Rod Ends
Mario
02-03-2006, 03:29 PM
Length From end to end:58.6 MM
These are brand new.
Great if you want to make your current wastegate actuator rod adjustable.
I have plenty available
$7 Shipped.
Blue Iroc R/T
02-03-2006, 06:45 PM
Length From end to end:58.6 MM
These are brand new.
Great if you want to make your current wastegate actuator rod adjustable.
I have plenty available
$7 Shipped.
What is you Paypal address? I'd like two of them.
Blue Iroc R/T
02-04-2006, 01:04 AM
Paypal sent.
Thanks :thumb:
Mario
02-04-2006, 09:19 PM
Thanks. You should be receiving them mid-week.
jaysshelby
02-05-2006, 05:49 PM
mario
send me a pic of this, i'm interested
my e-mail is jaysshlb@yahoo.com
also send me your paypal acc name.
omnivore
02-05-2006, 11:35 PM
How would one go about putting this in place of the stock non adjustable one? Does the stock one thread out of the actuator can? Do your rod ends have a hole in the flapper door end to attach to the flapper's arm?
Mario
02-06-2006, 03:47 AM
I'll post a picture tommorow morning. I really beat from today. The rod ends are simply that, the rod end. There is a hole for the wastegate flapper.
To use this on your stock wastegate actuator, you have to cut off your end, thread a short portion of the end using the die, and screw this on. :thumb:
Mario
02-08-2006, 02:08 PM
Picture:
Blue Iroc R/T
02-09-2006, 10:21 PM
I got my Rod Ends today. Work great. Thanks a lot Mario.
Mario
02-10-2006, 04:09 PM
No problem. Glad you like them.
Mario
02-15-2006, 04:07 PM
to the top
Mario
02-17-2006, 04:30 AM
Plenty left still...
Mario
02-22-2006, 05:05 PM
bump.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.