Stinkbox
01-31-2006, 01:17 PM
i started getting my setup done where im using a deltagate and a 63.a/r stage 3 turbine housing on my t3/t04b super v. i drilled a 1.25" hole underneath my #2 runner and got a 2" piece of pipe welded to it with a flange for my delta gate on my extra stock mani. after getting it done turns out i need to cut it and get it welded back on on an angle cause the wastegate body would be hitting the block. can't wait to hear this thing crack open and dump to the atmosphere haha. i also drilled the stock chrysler flange so that i can put on my .63 a/r housing. i still have to drill it out to the right size and tap it. i have a to4b compressor housing and a super v compressor wheel on my stock garrett stage 1 and .48 a/r chrysler turbine. im gonna be putting in a stage 3 turbine in the .63 as soon as i get the wastegate welded up right. then i have to get my o2 housing that i have cut and rewelded since it was made for a dsm i used to have, i have to swap over to a 2 bolt flange instead of the chrysler donut flange. can't wait.