Need some help choosing a ic

[Mr overkill]

I im in the market for a ic and would like one with a inlet and outlet on the same side

http://cgi.ebay.com/ebaymotors/FMIC-GODSPEED-INTERCOOLER-SPEC-A-FD-FC-MAZDA-RX7-RX8_W0QQitemZ120115426547QQihZ002QQcategoryZ33741Q QrdZ1QQcmdZViewItem


but someone told me that they are not nearly as efficient as a typical one side inlet and all

are they just as good or what ??


thanks

[Murphy]

you got to look on what way they floe. that one flows top to bottom so it is direct and flows good. some same side inter coolers are double pass, where it starts on one side, goes to the other then back, and out like this one

http://cgi.ebay.com/ebaymotors/27x11x3-One-Side-FMIC-INTERCOOLER-Mustang-Fox-Body-280Z_W0QQitemZ190109312216QQihZ009QQcategoryZ33742 QQrdZ1QQcmdZViewItem

[Mr overkill]

ok so top to bottom is good and the cross isnt ??

what about this this should work good
http://cgi.ebay.com/ebaymotors/Ford-Mustang-Bolt-On-Intercooler-30x6-25x5-25-FMIC-5L_W0QQcmdZViewItemQQcategoryZ33742QQihZ014QQitemZ 330116762866QQrdZ1

[Murphy]

the sharp 90* looks bad...

if you gonna go with something of that style i would look at a SRT4 one, i hear they are good to over 300hp

http://cgi.ebay.com/ebaymotors/SRT-4-Intercooler-stock-srt4-dodge-neon-turbo_W0QQcmdZViewItemQQcategoryZ33742QQihZ008QQit emZ180114609045QQrdZ1QQsspagenameZWDVW

[Mr overkill]

i am gonna put it into a g body and its gonna go though where the stock ic was so then i guess its gonna have to be this one then


http://cgi.ebay.com/ebaymotors/FMIC-...QQcmdZViewItem


the srt4 wont work unless im gonna cut up my rad support

[UPSIDE-DOWN-FACE]

i had an srt in my '88 shelby. i had to cut a little of the access metal that was on the sides of the rad. it wasnt structual though. and i did it with a cutting disk on a drill.
http://img.photobucket.com/albums/v358/kbriggs/910900810.jpg

[Mr overkill]

dont want to cut into the rad support

[tryingbe]

I im in the market for a ic and would like one with a inlet and outlet on the same side

http://cgi.ebay.com/ebaymotors/FMIC-GODSPEED-INTERCOOLER-SPEC-A-FD-FC-MAZDA-RX7-RX8_W0QQitemZ120115426547QQihZ002QQcategoryZ33741Q QrdZ1QQcmdZViewItem


but someone told me that they are not nearly as efficient as a typical one side inlet and all

are they just as good or what ??


thanks

That one looks good one to me for a single side inlet/outlet.