View Full Version : SMEC Plug
The S is Silent
01-24-2006, 10:28 PM
How the heck do I get this thing apart???
SMEC harness...the part that actually plugs into the computer. How do I get the pins out?
GLHNSLHT2
01-24-2006, 11:19 PM
ahh been there done that, know your pain. Look at the end of the plug that the smec fits into. You'll see the red plastic locks in there. I find the small blade on my swiss army knife works perfect for this. Now take the tip and pry the red pieces up just a bit, then put the blade between the red piece and the screw/bolt in the center and twist it prying the red piece out of the plug. It'll go POP! and pop right out. once these are out a small straightslot screwdriver can fit down there and pry up the locking tab and then the pin pulls out.
The S is Silent
01-24-2006, 11:21 PM
Thanks, I figured it out. That was a ----- to figure out.
One more thing...have you ever seen a wiring harness without a bulkhead connector? 88 CSX-t? This sucks.
minigts
01-24-2006, 11:28 PM
Matt, I think you and I are working on the same project at the same time.
:amen:
The S is Silent
01-24-2006, 11:36 PM
Nice charger. Is your freak harness going into your L-body also? Lucky us!
:thumb:
GLHNSLHT2
01-25-2006, 12:29 AM
yeah Shadows don't have bulkheads. :)
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.