Opinions on PG posies?

[Dave]

I need some opinions on phantom grip posi units. I know it's not a full grip posi, but it's relatively inexpensive and better than stock. I want to know for sure if it's okay to bust out some 1.9 60's in a 3,000 lb fatty. Will it damage the differential at all? How is it for hooking up? Does it allow both tires to spin in during a burnout?

Anything else I should wonder about? Also where can I buy one of these??

Any tips or considerations of other posies would be helpful.

Thanks,
-Bryan

[cordes]

They are a waste of time IMO. Get a OBX off of ebay. I recall somone getting one for about $250 off of there. They are a quaife knock off, and supposedly really strong.

They PG is just not going to cut it long term, and last I checked they were about $250.

[SwiftTech]

I ran the PG in my daytona for a while, it generally sucked and made the launch very inconsistant. It never spun both at the same time(unless on ice but being cali that doesn't happen very ofter) and was a general waste of time. I didn't even bother sticking it in the new trans I swapped into it a while back.

[sergio]

I have one. Basically a waste of money. I dug it at first, helped with corner exit traction in my relatively low-powered GLHt, but it seemed to lose effectiveness as it wore in (out), and it didn't help out the one-wheel-peel.

[Dave]

Hmm okay thank you guys. So the OBX knockoff Quaiffes are good?

[Keito]

Dave,

Will the OBX work in a 413?
I think that's what your using.

Check this out.
http://td.rcwebdev.com/forums/showthread.php?t=109284

[Dave]

Okay I Ebayed "OBX differentials" and found this: http://cgi.ebay.com/ebaymotors/OBX-LSD-HELICAL-DIFFERENTIAL-94-06-MAZDA-MIATA-MX5-MX-5_W0QQcmdZViewItemQQcategoryZ33731QQitemZ803402106 5QQrdZ1QQsspagenameZWDVW

Is this the one I want? Will I need to modify my case at all??

[The S is Silent]

http://cgi.ebay.com/ebaymotors/OBX-Helical-LSD-95-99-for-Dodge-Neon-2-0L-ALL-420A_W0QQitemZ8034090987QQcategoryZ33731QQrdZ1QQcm dZViewItem

That's the one you want.