PDA

View Full Version : Crank Sprocket Question


1qk4dr
02-24-2007, 02:20 PM
I need the width of the Crank Sprocket or any dimensions that you guys can give me. I'm going to find a way to make one.

Thanks,
Joe
turbovanmanČ
02-24-2007, 02:50 PM
Its the same diameter as a round tooth one, when I take mine apart, I'll measure it.
overlordsshadow
02-24-2007, 04:31 PM
If mine weren't at the machine shop right now i'd find out. Should get it back early this week. I'll post it if it hasn't been posted already
Turbo Joe
02-28-2007, 10:21 PM
sure it's 1.960 " wide, that is total width. there is a spacer that is machined in it that makes it a little wider, now just the width of the belt area is 1.853"
there are also recessed area's too.you'll need alot of dimentions.. not to mention special tooling..
1qk4dr
03-01-2007, 09:08 AM
sure it's 1.960 " wide, that is total width. there is a spacer that is machined in it that makes it a little wider, now just the width of the belt area is 1.853"
there are also recessed area's too.you'll need alot of dimentions.. not to mention special tooling..


There is a place up the street that specializes in sprockets and gears. I was going to see if they can't match it up with something else and see if I can get a machine shop to tap some holes.

I'm going to wait until I have a used one in my hands when I do talk to them.

Thank you
Lotashelbys
03-06-2007, 01:38 PM
I'm going to wait until I have a used one in my hands when I do talk to them.
Well,I could let you "borrow" one if you can get it copied if im GAURANTEED to get it back:D
1qk4dr
03-07-2007, 09:06 AM
Well,I could let you "borrow" one if you can get it copied if im GAURANTEED to get it back:D

I actually found one locally, thanks for the offer:thumb: . I should take it in to see if they can find a duplicate. Maybe I'll do that tomorrow or next week.
t3rse
03-07-2007, 12:20 PM
you can buy them from any auto parts store for 20$
Lotashelbys
03-07-2007, 07:19 PM
you can buy them from any auto parts store for 20$
WHAT?? Where are you finding TIII crank timing sprockets for 20 bucks? I will take 10 at that price! Are you sure about this???
t3rse
03-08-2007, 03:27 PM
my bad didn't read well enough....i'm totally wrong...
t3rse
03-08-2007, 03:28 PM
check this for making your own cogs...
http://www.aardvark.co.nz/pjet/gears.shtml

you can get a Chinese end mill for around 400
t3rse
03-08-2007, 04:37 PM
how about this???
http://www.partsamerica.com/ProductDetail.aspx?MfrCode=CLE&MfrPartNumber=S707&PartType=164&PTSet=A