Floating Pin Punches

[1985ShlbyChrger]

I'm machining pin pushers from aluminum at school. Can make getting those common "stuck" floating pins out easier. These won't work on pressed pins though, as far as I can tell. I haven't gotten one machined out yet to see if it will last for the pressed pins.You know how sometimes the floating pins are hard to push in and out, well I took some measurements and I'm machining some "punches" at school on a CNC lathe. I have 10 in the works right now, and the cost would be $10 shipped. I can make them from brass so it won't hurt the pin, not that aluminum should but that would cost a little bit more.

EDIT: Not sure if this is like TD.com or not in that i have to be a contributing member to sell things.