View Full Version : VAC Nipples?
Ground Rat
01-27-2007, 04:42 PM
I have a bare FWDP vac block and need to pick up some 1/8th and 3/4 NPT nipples for it. Where did you guys find yours?
contraption22
01-27-2007, 04:45 PM
www.mcmaster.com
Speedeuphoria
01-27-2007, 05:52 PM
hardware store
GLHSKEN
01-27-2007, 06:25 PM
Autozone
mcsvt
01-27-2007, 06:28 PM
Home Depot :)
Mysterio
01-27-2007, 08:20 PM
I couldn't find any 1/8th in thread 1/8th in nipple fittings at home depot or lowes. I ended up ordering them off of fittings4less.com I think was the site. All HD & Lowes had were 1/4'' thread by 1/8'' nipple. I didn't even think to try mcmaster that prolly woulda been a better/cheaper idea if they've got em.
cordes
01-27-2007, 10:44 PM
I picked up a block that was 1/8th NPT and then I drilled and tapped it for the 1/4" fittings. It is a lot easier to find a variety in 1/4" as most have noted.
Birddog
01-28-2007, 12:30 AM
Most HVAC supply houses have all that stuff... Brass 1/8 nips, 90s, and butt connectors.
When I did my vac block I drilled a piece of 3/8 brass pipe and soldered the connectors in.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.