View Full Version : EFI Tuning
- MPTune on Linux
- TIII Boost Control
- Turbonator TIII fueling and spark tables
- turbonator T3 - idle and warm start issues
- Turbonator auxiliary temp input
- Turbonator flags
- MPScan RPM
- TIII Tuning: Is Megasquirt Worth It?
- What is CarSpeedForRevLimitWithTBOff used for?
- MPScan logging AFR and ECU parameters with logic module
- Maybe some problem with FTDI chips are caused by this?
- Windows 10
- datalogging for PefTb tuning in MPTune
- Holley 950 comander tune
- Does my PumpEff table look crazy?
- 3.0 SBEC Turbonator development
- Question about Turbonator cal timing
- WG Solenoid cycles per second vs duty cycle
- mpscan trouble shooting
- What Causes Nonsense Fault Codes?
- Pulling a tune out of a flashable SBEC?
- O2 sensor warm up lean idle when warm?
- Convert .bin to .tpl files
- Is anyone running an Ostrich and been able to get MP Scan or MP Scandroid to work?
- How do I set REV limit in T-LMv13
- battery / ambient air temp scale
- com port issues
- MPSciLink
- TCM Reverse Engineering Project
- High RPM breakup
- way high idle on cold startup, then runs lean and stalls
- High Boost using MPTune
- Boost Button T/SBEC Stage II cal
- Help troubleshooting MPScan
- Code 36 is not shut off, even when it is suppose to in T-LMv13
- Ultra lean idle until CTS reads 100f
- Failed Smog Check High Nox :(
- mptune / mpscan update
- Sensor maps for guages to make dash in Logworks?
- MP tune points moving when I click on them?
- Boost Control Not Working in Certain Turbonator Cals
- TMFrench's post not working
- Way lean unless I have the pumping effencincy table maxed out.
- Flashable sbec issue
- SBEC chip burning question(s)
- 1 Bar MPI Cal for Logic Module?
- Show your Gauge Layouts of MPScan
- Need help with WB2NB
- Swirl head race gas timing curves
- Flashing from MPTune
- MP Tuner quit working and gives error when try to open anything??
- Who has successfully installed MPTune with Win10?
- .tbl for 92 2.5 MTX SBEC anyone?
- Open a .bin fine without a .tpl fine in MPtune
- Open stock cal repository cals in MPTune
- Help me better understand Wategate tables in MPTune
- binstacker how to?
- MPTune on line tables
- 91-95 Jeep SBEC tuning
- 1989 Dodge RamCharger 5.2l Tuning
- Looking for someone that can burn a 670 MP chip for a long time TM owner
- 1987 Daytona T-II logic module question
- I need a "Tutorial" for getting set up for MPTune
- TBI Code Base?
- analog input ports
- Jeep SBEC Flashing/Questions
- Tuning questions, knock related and cutout
- Turbonator Is there a fuel table for a/c?
- Two problems with turbonator cals
- New person for custom cals?????
- SBEC + ostrich Fix
- Boostbutton boards
- MPtune Download?
- Tuning MS would like some input
- 3.0L Tuning
- Tutorial for Spark Tuning
- time for a chip.
- Trying to set rev limiter on a LM?
- MPscan issue or bad VSS?
- MPTune not loading .BIN file...
- Regarding pressre measurements
- burning 27sf512
- MPSCAN and Logic Module Problems
- Ok to solder ftdi cable to LM?
- Nice little device for MPscan/MPtune
- FWDP T-III Stage 3 computer
- Can't install MPTune or Scan on New Computer
- SBEC Chip source?
- Error loading when I load a cal in MPtuner
- mptune wont open
- VNT T-SBEC issues
- Adjustting the Battery Offset table?
- turbonator LM V13 2.5 MTX Custom boost control?
- Help needed! Cal for an 86 glhs
- MPSciLink device pre-order
- MPTune issue, using flashable SBEC
- BoostButton Calibration
- 2.4l Turbo SMEC Cal
- SBECsim
- MPSciLink starting a Group3 Pre-Order
- The inaccuracy of HEP and distributor is causing you to lose power.
- Flash module (and other stuff) availability update
- 2.4 t-smec rev cutout - launch control?
- Bad LM causing CEL flash on knock problems?
- Error loading calibration/binary in MPTuner
- Turbonator_wiki Cals rich in the Winter?
- MAP & CTS sensor questions
- Red 16V TC Masi runs clean AF!
- Flash module flashing issue
- MPScan USB FTDI cable advice
- 2.5 G head cal
- SMEC Fuel Trim logging
- LM GLHS calibrations
- cold idle hunting (goes crazy lean) & iat rwads 102º on scan tool all the time.
- Spark or fuel cut issue/New to tuning.
- Corrupted Boot Program MPTune
- GM 3 bar MAP scale constant / multiplier
- MPScan says that I have 42 degrees advance at an idle
- Charge Temp not available on MPScan
- Knock sensor too sensitive?
- Will Socketed V6 SBEC work in turbo 2.5?
- Are latch board and chip extender compatible
- New FB group for MPSuite support (MPSciLink, MPScandroid, MPTune & MPScan)
- SBEC/ SBECII TIII Flashable ECU Chips Needed
- Socketing the SBEC
- mpscilink 2.7 setup
- Flashable SMEC Module
- Barometer reading off?
- Simulator research
- Chip reader/burner for SBEC chips
- Difference between TIII SBEC and SBECII
- Mpscan gauge selection
- G head values for SMEC calibration
- Knock threshold
- MPSciLink possible Group4 Pre-Order Interest?
- seeking information on boost button SMEC & SBEC flash modules
- I need to borrow a DRBIII ... Anyone in SE Michigan have one?
- Deceleration RICH condition?
- MPSciLink Device Display Install
- Microsquirt v3 trigger wheel?
- Updating the MPSciLink Nextion Display
- Dcal style bin and table in MPtune
- MPtune on an old MacBook Air
- SBEC injector drivers
- Boostbutton tuning wiki?
- Sci/FTDI cable issues
- Way to rich cold start
- Fourplay how to
- Couple SMEC questions about boards schematics
- Different part numbers the SBEC2 PCB board
- There are two very different SBEC2 PCB---Wow are they different
- Gauging interest in a new high capacity LM/SMEC/SBEC/SBEC2 flash module
- Diferences between SMEC versions
- FTDI cable setup
- Boostbutton Flash modules for SMEC/SBEC/SBEC2
- SMEC chip
- Chip programming
- Programming
- One way zener diode
- Distributor pickup voltage @ the rev limit (6650 rpm)
- ECU vs EPROM and flash module
- FTDI adapter help
- Stepping down voltage
- Boostbutton hardware assembly
- No fuel/spark with emulator.
- Scanner not working with Ostrich 2
- Megasquirt TIII coil control
- A/C idle set Turbonator SMEC
- SMEC cal for 88 TII on an Ostrich
- New Flash Product Development, and Pre-Order interest
- Sbec t1 MPTune/Scan questions
- MPSuite programs available again
- Did I kill my Knock Sensor Circuit?
- Injectors, Regulators, and MPTune.
- Needed: ANY CALs for SBECII 8 valve
- New tool for the electronic lab
- Adding cruise control
- SMEC Dissassembly
- Boost drifting downward
- Incomplete install on windows 10 and 7
- Socked smec in an 89 Shelby Dakota?
- MpTune
- MPFlash Batch#2 Interest/Pre-Order List
- Mpscan - lm
- Ostrich - GLH
- MPScan wont record
- Using a V6 SMEC in a turbo application
- Computer needed for mptuner
- Unable to tune with MPTUNE
- BoostButton SMEC WB2NB Glitch?
- Tuning for 14.7:1
- MP Flash switch setups
- Rich Idle tuning
- logging with mpscan question
- tuning questions
- Microsquirt
- No no build Tuning question?
- knock sensor dead ?
- Error bit mask in MPTune
- Cold Enrichment Tables CurveA, B, and C
- MP tune
- MPTune and Ostrich - Boost cut-out around 11+ psi?
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.