View Full Version : EFI Tuning
- T-SMEC/SBEC boost control
- Need help with pumping eff table and other tuning issues
- IAT sensor question (again :D )
- Setting up Com Port on USB Pocket Programmer
- HELP! Logworks plug-in can't init serial port
- What is the best setup for burning chips for a LM?
- Lean on Tip in
- Adjusting the boost control
- PumpShot Calculation
- Rich during warm up.
- 2.5 swirl head tuning, Round 2
- Turbonator Templates - new grouping
- Megasquirt thoughts.
- Anyone using the Ostrich or chip extender and having issues?
- Protocal for Logging Data
- Flashable LM's
- 86 glhs t2 lm
- SST27SF256 or SST27SF010
- LM boost control v. boost spike problem
- Megasquirt info needed
- Table to adjust open loop fuel - cold ECT?
- Turbonator switchable boost using P/N switch
- SBECII Type II?
- how lean is too lean for idle?
- VNT options?
- Super 60 cal set for pump or race gas?
- Distributor Reference Decoding...
- Netbook vs laptop for datalogging?
- Megasquirt soldering question
- O2 kicks / lean cruise
- v6 computer
- Bootstrap 90 SBEC
- Which boost button stage cal is equal to fwd stage 5? also fuel/injector question?
- MP computers
- How to figure what sort of calibration I need
- Swirl head timing and megasquirt
- Quick initial timing question
- Another quick timing question
- Knock on CEL coming on, when knock sensor isn't even connected!
- Minimum timing limit in SMEC
- commanded AFR
- Ostrich/Emutility problem
- Knock voltage readings and thresholds
- Tuning Charge air temp Sensor
- Setting Idle speeds in T-SMEC How?
- '93 Jeep 4.0 stock cal?
- dcal linux
- Clutch Switch?
- '87 TBI Logic Module
- Flashable LM?
- proper way to set timing
- Slow RPM decel to idle
- Overboost is killing me!
- SMEC Map?
- 89 2.5 converted to t2. Can I use t2 smec?
- help with mptune version 2 and ostrich
- rich idle/decel
- Help with Willem eprom pcb50
- Missfire under boost
- How to install FTDI module in a LM?
- USB Wiring Pinout for the factory code reading plug thingy
- Disabling Purge in MP Tune
- Anyone have the table for logworks that for boost?
- is there a way to disable o2 feedback in dcal?
- Dynoed at 8 psi
- How does my air fuel ratio look? (videos)
- Can't open cal in MPTune
- Wide open throttle shifting? (WOT shift ignition or fuel cut)
- Swirl vs G-head PumpEff table
- Stock afr?
- AFR Datalog?
- adjusting points in MPTune
- View SEMC Data
- Can't open any cals--Friday the 13th I guess
- Is there a 0-5v to absolute pressure caculator?
- Overboost with lm stg 5 Shelgame cal
- Nice sparkplug cross reference site...
- Bosch A/F Sensor Differences?
- Why does my van like soo much timing????
- Stage IV cal won't change fueling?
- A few simple tuning questions...
- Minimum Timing Differences??
- T-Smec 2.5 G-head Thoughts
- How do you calculate total timing?
- Spark advance theory.
- Part to Full Throttle switch point
- Knock sensor gauge idea!
- Help with MPTune
- Where to buy SBEC chip adapter?
- 3 bar to 4 bar MAP voltage questions-mainly alky controller settings?
- help me with boost control on my Tsmec and Boost button cal
- Quick spool spark retard?
- Help Please With Innovate SSI-4
- So what are you guys doing about 4th/5th gear knock?
- Lean spike around 0-5" vacuum
- After Socketing
- Limp in mode, can't figure out why
- MPTune Video
- Chrysler Co-Pilot - anyone ever use one?
- Post up your Pump Efficiency Table!!
- Wideband readings
- AEM wideband signal output question
- Wifi for ostrich 2 ?
- Wiring up the Boostbutton USB cable.
- What is this Logic Module?
- Confused with MPTune
- Stage Cal Timing vs MP Cal Timing
- Tuning a SMEC to run a SRT-4 2.4
- T2 boost control using Mitsu
- Fuel Cut on Decel and part throttle AFR Question
- Rich Stumble When Cruising
- using air intake temp input for wideband datalogging.
- 91 T3 SBEC1 Tuning Questions
- Problems with MPScan
- '95 Neon ECU Tuning
- LM turbonator pumping table not looking right need some help
- Share you're 2-step setups w M.S. and other systems-
- Part Throttle Unlock (auto trans LU converter) discussion & theory
- So has anyone figured out exactly how the O2 ramps work?
- Rich Misfire Issues at Cruise
- No Lift Shift Discussion
- Holy Crap Confused
- Board diagrams for TI/TII vs TIII SBECs
- Neon ECU flashing
- ECU Tuning Options
- Megasquirt and 2.2/2.5 mode who is running it?
- MPScan and USB to SCI cable
- Flashable LM or Super LM?
- setting Rev Limiter in LM
- Minimum timing still have knock
- o2 ramp controller
- Dyno-tuned my Dad's wagon today
- Spark cut Fractions - MPTune
- Turning fan on under boost w/cal
- Audible knock with new A/W intercooler
- 3-Bar cals with Cruise Control?
- pumping eff change for big valve head.
- Timing Calculation Min and Max. How do i use them?
- Mitsubishi TI vs Garrett TII Boost Control Explained
- Stumble under hard accel
- What to log-MPScan
- turbonator cal questions
- exhaust backfire high rpm
- New burner or????
- Cruise control for max MPG?
- 3 bar scaling issues Tsmec
- MPScanDroid
- Need Megasquirt2 (ms2extra) testers for stock wheel decoder
- MPScan dashboard config
- '85 Logic Module - which chip?
- '85 Mopar Performance tunes
- Slugmobile's datalog anomalies
- Laptop for flashing and datalogging.
- Instuctions for flashable SBEC install
- High Idle RPM
- Auto vs. manual timing advance
- 3 bar scaling with LM. Running rich.
- MP computer issues
- 2..5l G Head Calibration
- More boost less timing, less boost more timing???
- Need to adapt GLHS cal for automatic use
- egr removal for LM
- Tuning help, dieing on decel, idle problems before O2 warms up....ect.
- Datalogging has me pulling my hair out! MPScan & Logworks Plugin
- Interesting piece of LM history...
- Thoughts on SDS system.
- MPScanDroid
- Help: Turbonator/custom cal initial timing setup
- Which 3-bar map?
- Would my tune make my car have no power right after I shift?
- 2.2 SMEC cal.. anyone want to share?
- E85 tune made from 91 octane tune, how to.
- MP Tune, issue with Ostrich and COM port`
- 1st time SBEC chip burning question
- mptune for android
- Turbonator Boost Control T1 or T2?
- Tuning help for a TIII using MPTune
- Bench Flashing a SBEC--How do I do it?
- Problem tuning for 25+ psi of boost
- Will the stock boost solenoid work for high boost
- MPTune rookie question
- Learning resources
- Turbonator Staging Limiter on SBEC questions.
- Flashable FourPlay?
- 351ve Holset how to control the factory actuator
- Volumetric efficiency
- Knock sensors revisited
- Re-Chip with new processors
- Limit for Hot Map Advance
- Scale percentage for 40+ imjectors
- GLHS cal idles fast on decel
- Flashable SBEC vs Ostrich
- Lean on cyl 1 and cel flash with new cal.
- Comparing two cals with MPTune/MPCompare
- Few questions on the flashable SBEC?
- MPtune boost cutoff/limit set?
- help with new setup
- Converting old calibrations to MP tune
- no com port mptune
- FTDI Cable and macbook bootcamp windows combo not working?
- mptune retrieve initial tune
- spark scatter...what's normal
- No COM port
- egt temps at idle high
- No boost control with Boost Button lm 22 S-IV tune
- Help tuning a 2.5 hybrid
- smec cal mechanical spark advance question
- Looking for a good base cal, 2.5 fully ported swirl and big valves
- Newb tuning questions.
- Need datalog results for 2.5 with standalone ecu
- Turbonator Nitrous Timing retard
- Ethanol calculator and tuning question
- Target idle speed table
- mpscan help lm guages and graph twitching from min to max?
- car stalling while cruising after mptune turbonator tiii flash
- Turbonator Pump Shot tuning
- Programmers/Burners
- Big turbo anti lag tuning
- Newb looking into tuning
- Shopping for a 4 bar MAP sensor
- MPScan charge temp sensor reading.
- 2.4 knock sensor
- Knock Sensor location idea
- Flash Module Version 2 - Interest?
- SMEC tuning, Throttle / boost correlation
- E85 Tuning and what tools will help with the tune.
- Some early TC by Masi with no knock sensor?
- Upgrading LM cal to 4 bar
- need a custom cal A.S.A.P ..
- MPscan issues
- Ostrich draining car battery
- Ambient air or intake air temp modifier
- How to log a 0-5V source in MPSCAN / MPSCANDROID?
- What's the deal with 1989 electronics?
- Troubleshooting with MPSCAN
- SMEC Filler material
- MPTune: Editing Fuel/Air Settings
- MPScan LM Log file
- 2-bar vs 3-bar
- Issues with mp tune. Please help!
- Setting the launch control in MPTune
- Computer controlled boost turbonator
- Video of Turbonator Staging Limiter in action?
- Turbonator cal: WB2NB use issues
- Looking for PumpEff table for ported swirl
- PumpEff adjustment via Turbonator wiki
- Gauge's in mp scan
- Nitrous Caravan at SDAC 25
- Looking to possibly run ethanol, have some questions...
- Transient fueling adjustments
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.