View Full Version : Transmission
Pages :
1
2
3
4
5
6
7
8
[
9]
10
11
- A413 transfer/pinion shaft bearing endplay or preload?
- Small Diameter Ultra Lite Multi Disc Clutch and Flywheel Assembly for the Dodge 2.2
- +1 for Pennzoil Syncromesh
- 1998 Caravan a-604
- 568/523 bearing sleeve problem
- A413 Carnage!! Figure this one out.....???
- 3.6 Pentastar 3.6 to A604
- diff pin
- Pictures of cable routing in a L body with 555 swap.
- 555 random synch issue?
- G-Body Rear Motor Mount Needed?
- Transmission shifting issues
- L Body 568 Tranny Mount Issues
- Torn CV boots.
- Equal length axle question
- a413 4100rpm stall speed at 13psi
- 90 caravan 5spd transmission ?s what all transmissions fit?
- 90+ van shifter cable lengths
- Flywheel bolts
- 2 piece transmission mount
- A568 Differences
- Purple plate and 4 or 6 puck disc?
- A555 With Shift Linkage
- 1993 Duster 3.0l need trans.
- A604 / 41TE genusis needed!
- L-body shift linkage
- Want to put an auto behind my T2.. HELP
- Want to put an auto behind my T2.. HELP
- manual shift cable
- G288 in my neon
- need advice on fixing the shift linkage for my 86 5 speed charger trans
- L body/558 Clutch Cable
- Neon valve body phenolic ball location
- ??
- 604 not upshifting?
- This is how a broken VSS would look to the computer
- R/P Pitch for 568.
- shift kit for a 413 3 speed auto
- Which clutch should I use?
- possible to replace pinion bearing on int shaft?
- Shifter cable snapped
- tranny go boom. (sorta)
- 'Cast" Planet Question
- throttle off rough shifting a413. shifts butter smooth under any kind of thrttle
- High stall torque converter and stock 2.5
- Where is the vent
- Lebaron 2.5 Turbo - Drive axle Lenght
- A413 transmission kit questions
- SDS - Speed Distance Sensor - vent cap?
- Clutch release bearing.
- Welding Band and Planets
- A413 No Forward Gears, Has Reverse
- Valve body mod in trans kit
- Aluminum shift cable bushings
- 1991 clutch in 1990 trans...
- 93 Sundance 5speed trans into 2.5 turbo mini?
- NAN converter
- Transmission Planets
- Clutch pedal bellcrank, van vs car
- Van clutch cable length
- Servo / Accumulator o-rings - Getting stuck in snap ring groove
- 5th gear whine
- 89 Grand Caravan Turbo 5 speed swap
- 88-90 Omni CV boot part numbers
- Flywheel bolts 8 bolt crank Stock vs ARP
- which clutch?
- A413 output shaft setup
- suspension popping
- Some basic auto trans questions and modifications.
- Techniques used to tighten output and Transfer shaft nut
- Replacing L body hanger bracket bushings, necessary?
- A413 auto - no reverse issue
- A413 Another way to "Lock" Transfer and Output shaft
- Is NOT using kick-down cable hurting my trans???????
- a413 advice needed.
- HOw rebuilds our manual transmissions
- Shifter bushings upgrade...
- Suddenly no reverse or 4th in A555
- L body shifter assembly pictures needed
- Need some clutch advise!
- 91 Daytona Shelby Auto to Manual Conversion
- a413 shifting late into 2nd and early into 3rd all of a sudden
- Manual Valve body no engine braking in 1st question
- Line pressure RMVB?
- Clutch replacement guide?
- 5 speed stuck in gear. Hit starter, car moves forward or synchros grind.
- a543 Pinion sleeve almost worn through the case...
- Torque Converter Advice
- 04 jeep liberty 42re tranny
- a523 stuck in reverse after cable popped off
- What axle do I use????
- awd swap into 2.5 turbo caravan?
- Bolt info.
- quick 5 pinion planetary question
- 2.2/2.5 rwd sfi approved bellhousing ??????????
- Damn SPEC clutch
- Adding extra boss to tranny for 2.4L installation
- input shaft spline grease (installing new clutch)
- Help Me Choose a Clutch
- N/A clutch capability?
- Anybody broke an OBX posi unit yet?
- A465 - Garbage?
- 3.05/525
- pistol grip in 88 shelby z
- What model tranny do I have?
- A413 friction plate teeth
- Poll: MPH in the 1/4 vs Stock diff or ???
- Rod shifted A568 possible?
- Diff cover torque specs
- Are the factory keeper clips enough to keep the rods link a 525?
- Identify these fork pads!
- Do a465 guts work in a520 case?
- Shift cable adjustment.
- a413 something napped/broke any ideas? Van will not move.
- Clutch Cable Manual Adjuster
- torque converter compatability
- Tools needed to remove a413 Transmission
- No motion in any gear
- Pressure plate alignment/dowel pins
- Shift cable retaining clips
- Inital Impressions of TU Ultimate 4-puck Feramic Race Clutch Kit
- Parts needed for 5 speed trans swap; 1990 trans into 1989 caravan ?
- Governor weights ??
- 555, 523, 568 ???????????
- The typical A568/A523 shifter cable problem
- a568 trans whine ? and clunk or pop sound.
- Closing up my transmission business
- A413 Down Shift Issue
- Torque converter
- Shifter Questions
- New Billet Transfer Gears
- 3.3L Driver side Saginaw Axles do not fit into 5 speeds (at least 3x for me)
- Scrapping a Neon ATX - What to Salvage?
- awd guys need help with seals
- Identify these bearings?
- Part #'s to rebuild L body 525 linkage?
- A few transmission improvement questions...
- a523 trans leak on rear shifting arm.
- A-555 teardown video
- 555 leaking from the top???
- need replacement speedometer cable adapter in transmission
- So much for the indestructable A-568
- 555/520 hybrid intermediate shaft bearing
- Aluminum flywheel for 2.2 turbo engine
- trans 520/523 ?????????
- Minivan Transmission Issues?
- Another Minivan 5 speed swap
- transaxle seals
- lbody ps axle question a568 in lbody
- Part throttle kickdown after shift kit....
- '89 Daytona reverse lockout cable/strap
- CV Joint Disassembly Procedure?
- A604 ID help needed
- A-568/523/543 vent tube . . . I'm confused
- OBX install in a A413
- Adjusting shift timing via governor weights
- clutch adjustment advice 555 trans
- Transmission options for my build, a413 or 41te
- 3.05 ring and pinion
- 3 speed auto help
- a413 dropping 3rd gear
- A413 locks up hard in reverse
- A413 - welding planetaries
- Shelby Limited Slip Diff
- Torque specs for 6-bolt flywheel
- Clutch plate diaphragm finger wear
- Centerforce pressure plate
- is the 413 axles biger
- Lbody a520 swap
- A523 leaking somewhere over differential case area
- is the speedo gear the same?
- looking for flywheel to fit a 89 t1
- A413 Lockup Converter and Input Shaft same as A604 Lockup Converter and Input Shaft?
- A413 trans cooler check ball info.
- Best Flywheel for me ?
- Carrier Bearing Part Numbers?
- L body shift linkage adj help
- Input and diff shims?
- 1990 Dodge Caravan, pick-n-pull Oakland CA, a523 5 speed
- A555 Intermediate Shaft Bearing Check
- Look what I got in the mail today
- 413 Bearing Question
- A555 Dif Pin Scuffs
- 88 p body 5 speed conversion
- Trans bellhousing
- Input shaft sealant and seal question
- 87 CSX 5 speed what will it handle?
- Speed Sensors
- A555 Main Shaft Race Issues
- Clutch longevity
- 413 band welding
- Raybestos high energy Kevlar vs tan bands
- 523/543/568 shifter housing repair with part numbers
- Band Relining
- synchromesh fluid expanding?
- 1990 daytona a-523 have 3.50 gears?
- a520 to a523 swap
- Correct hose line hookup
- Re-use ring gear bolts?
- differential bearing race removal
- If I needed an a/t
- How to tell if Shelby Limited Slip
- Sealing up the transmission - RTV? Something else? Lots of questions!
- Atx problem? Maybe?
- Transfer gear loctite question
- 6-bolt flywheel torque spec
- 91 RT 568 axle seal?
- 91 and up large spline disc compatibility?
- 568 Trans Rattle
- So which hole does it go in...
- Did OBX mess up my LSD?? (long post)
- Grinding when going into reverse
- I cracked my 31TH trans case
- When to chrome-moly endplate?
- clutch recommendations
- 520/555 Alternative pinion bearing (HONDA bearing version)
- Finally got my Hurst shifter in
- valve body question
- Tranny Locked up
- GKN axle weak spot
- Hurst Pistol Grip Lenses
- input shaft seal
- a 555 quaife lbody
- Suggestions for where to get a CV Axle rebuilt
- Dead A413
- WHO here has broken a CV AXLE?
- Where did the metal come from on my a555 magnet see pic
- Quaiffe diff, axle fitment issues
- which T2 clutch year fits 84-85 A525
- GLHS cable shifter
- A-555 vs. A-568
- Identifying 525 shifter cables
- welded diff question
- Another 568 / 523 hybrid question
- Lost 1 & 2 in a A-568
- are early 525 axles same length as 523s?
- bought a csx which transmission?
- new 6 puck from turbosunleashed
- adjustable clutch?
- Van 5 speed conversion parts, are 1st and 2nd gen parts interchangeable?
- lets talk about custom, skys the limit, tranny parts
- how do you block the accumulator valve on the A413 ?
- Auto Trans Fluid Question
- 92+523 vs 568
- A few questions before I mod my VB.
- Flexplate balancing?
- To pin or not to pin that is the question
- OBX LSD Discussion
- Can I gear up my 413?
- Replacing passenger side driveshaft seal
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.