- Timing belt changing video?
- Main studs
- How badly does a intake manifold heatsoak on a 8 valve?
- switch from log to one piece intake.
- Block interchangeability
- Rocker arm ratio
- Cylinder head interchangeability/advantages primer?
- Assembly Lube/Paste
- Cometic MLS .027 Gasket Torque
- Piston to wall clearance 2.5 with wiseco pistons
- 52mm TB Vs 58mm?
- 2 piece intake injector change question.
- long term cam storage
- 782 big fitting
- Oversize valve thread
- Intermediate Shaft Locked Up
- Engine Teardown, What am I Looking at?
- bolt specifications
- Cylinder head opinion
- best throtle position sensor, for 3.8 TB? my charger goes though them way to quick
- Type of phenolic for gaskets/spacers
- Big intake stock head.
- 2.2L TII Head Issues
- Making an 89 Lebaron run in the 12s
- Swapping valve springs in the car
- Is it worth it?
- 2.5 one piece intake manifold modification
- High idle
- 782 mp12 head vs 782 mexico head
- Oil in Coolant
- Head Porting
- Which TB to choose ?
- Lost another one
- Read These Plugs
- is there a "hard" compound 2.2 rod bearing???
- Wall Thickness For Intake
- Found an old MP 5 keyway cam sproket
- TII intake thread pitch for air charge temp sensor
- Head locator pins missing - big deal or no?
- Main Bearings Ford Big Block????
- 3D printing cylinder heads ???
- P4452006AB Headgasket any good?
- 87 Turbo 1 engine rebuild and upgrade
- 2.0 deck height
- Unexpected AIS behaviour
- +1 Valves
- BMF intake fuel rail mount bolts
- '89 CB Crank Sprocket Removal
- How much can a TIII crank be cut?
- looking for thoughts on different 4th cylinder cooling options
- Help identifying block please
- Rebuild options: advice needed
- 2.2 Common block windage tray not welded
- Head swap, is there a tips thread?
- 1mm longer valves
- Chinese Heads
- Factory Cam Specs
- Harmonic Balancers?
- '89 TII Camshaft Help
- Anyone have experience with adj. cam sprocket?
- Prototype Two Piece Intake?
- Turbododgeparts.com affordable cylinder head options?
- Oil pickup o-ring
- Cam seal sizes???
- Stamped letters on rails
- Oil pick up mods
- +1mm valve differences
- 2.7 and 2.4 Use same transmission?
- Old style TU R-4 cam
- Bolt spacing
- S-60 "roller" grind soon to be available from Comp Cams?
- Richard Holdener's LIVE YouTube channel 7PM CA Time Sept 21
- Engine rebuild tool recommendations
- Davis Vizard
- piston's ?
- Changing valve springs
- I have this situation.
- 2.4 motor mount for L body
- Measuring Cylinder Bore for Forged Pistons
- 8V head cracked, but is it bad?
- Just pulled head and engine/ trans today. 87 2.2 T2
- Distributor drive tabs have been freed!
- Cam cap studs
- 2.5L Crank shaft connecting rod journal sizes.
- Turbo Camshaft specs/cam gears
- changing valve seals on my Charger