View Full Version : Turbos & Intercoolers!
Pages :
1
2
3
4
5
6
[
7]
8
- Real turbo oil return setup
- Oil return torque specs
- Mitsubishi TE04H Potential?
- What One?
- This TII turbo only made 9 psi
- Turbonetics T3 bolt pattern compatible with Ford 5 bolt pattern?
- 3.0L Turbo
- Evo 9 intercooler in L-body
- Stock T1 mitsubishi inlet/outlet size measurement
- intercooler questions
- T3/t4 50trim or 46trim t3/t4
- T1 Log to T2 check valves
- Grainger Valve Install Technical Question
- rebuilding a leaky mitsu?
- Minivan intercooler
- Oiling a Mitsu - restrictor? Return line size?
- Siliconeintakes.com reviews...
- Oil/Water cooled to Oil only Turbo
- Wastegate bracket options.
- holset install ques
- Turbo fitting size and routing questions.
- big intecooler= questions
- Bore out a t2 comp housing or weld a 45 on this one?
- teo4h porting
- Intercooling an 88 Turbo I
- L-body turbo removal?
- wastegate keeps getting stuck open
- Questions regarding the factory turbos
- turbo seals
- EBay turbos for parts?
- 1992 daytona iroc r/t rattle and smoke issues
- Making a non adjustable wastegate can into adjustable....
- studs and or nuts for TU stainless turbo manifold
- factory boost controlling help
- Installing TU stainless header questions
- Ideas/Help - '92 Lebaron 3.0 V6 Convt Turbo Build
- Turbonetics Super 60 F1-49/BB
- Swingvalve to turbine housing bolt pitch?
- Turbo may be shot
- Garrett wastegate help
- turbo line orifice question
- So what exactly is an Ed Peters Super 70?
- Port turbine housing for more flow or Extrudehone??????
- twin turbo 360 rpm limit?
- No boost control after 3" exhaust
- GTX35R vs HE351 with an HX turbine wheel?
- what fmic for rampage?
- testing an wastegate solenoid on 89 chrysler lebaron teo4e
- 1989 Dodge Lancer Shelby Air Box Needed
- What to do
- Putting BOV in 89 Dodge Lancer Shelby
- BOV; What happens to the various stock chrysler blow off valves over 15psi?
- T3/T4 Tranny Buster E Style Turbos using stock exhaust manifold with elbows
- Turbo not spinning at idle
- Air filter placement.
- spirit intercooler advice needed
- Oil Cooling
- Best way to run Intercooler Piping on 89 Voyager?/ Intercooler Choice?
- Stand alone & external wastegate boost control
- Compounds revisited; Any TMers running them?
- DBB turbo on an 8 valve
- Ball bearing turbo? Worth it?
- Anyone have any info on air to water ic but with using ac instead of water?
- turbonetics t3t4
- Surge issues with 2.5 mini and garret
- Porting 2.5 T1 Voyager stock Mitsubishi Turbo
- Anyone ever heard of Fastwayracer.com?
- Turbo tear-down
- Checking air filter restriction
- Holset in omni
- Do turbo spool faster with milder cam?
- BOV Filter
- Where to buy compressor wheels?
- 97 Eclipse rough idle
- Good turbo for me?
- how do you know if a turbo needs balanced?
- Turbo rebuild kit T3/T4
- Turbo balancing machine
- Dual port wastegate can questions
- Gbody ic rad combo In a pbody with Ac fitment?
- Going to upgrade to an air/water intercooler
- T3/T4 rebuild, stumped
- help with turbo big block
- Borg Warner EFR turbos
- Best way to control boost?
- '89 CSX VNT Turbos...
- Reclock stock or swap?
- wastegate can
- Adding a Intercooler a 85 New Yorker Turbo I
- Turbo help hybrid or holset?
- Looking for some pictures of aluminum pipe fab with stock t2 ic
- Intercooler install on 91 dodge spirit rt 16v
- HX40 with a billet wheel-alternative choice?
- turbo oil drain hole cleaning ? in car ? Vigo's article ?
- Changing to a larger compressor wheel? Diesel related.
- Modifying a TurboXS RFL to not be so RFL?
- stage II or stage III
- PCV system in to ??
- Boost spike, how to fix?
- Pics of wastegate bracket please
- Oil in '86 TI Compressor housing
- what do you tmers think about pricision 5431 turbo on 8 valve engine
- Proven intercoolers that work (looking to upgrade)
- Full size TI/TBI radiator in Spirit R/T
- Has anyone used a Diesel Jeep intercooler?
- Which WG can T1-T2 conversion?
- porting a he 351?
- WTB good rebuildable Mitsu Turbo
- Need a new turbo for 8v what are my options?
- Grainger valve vent hole size.
- 89 daytona intercooler mods
- Omni...intercooler under the car?
- Home made manul version of a electronic boost controller
- Electric boost gauge and temp gauge
- Treadstone TR82
- wastegate solenoid delete, good or bad?
- Vacuum lines for SMEC-controlled boost?
- Gt35r into 89 Daytona
- Stock Boost levels for 1992 Five-Speed?
- turbo for t3 omni
- GN turbine fits stock dodge turbine housing?
- Holset HX35 Compressor wheel upgrade and rebuild
- MP performace computer
- Should have stayed with the Super 60...
- Where to get Greddy spec b connector?
- Turbonetics rebuild parts.
- Air to water IC thoughts/question
- Turbonetics T04E Interference With Starter
- Garrett Wastegate Cans - an idea!
- holset he351
- Smallest external wastegate
- Turbocharger Compressor Outlet Force
- External wastegate and turbine housing wastegate hole
- How would this intercooler work?
- Turbo boosting mystery....
- T3 88 csx intercooler choice help
- Four turbos gone bad
- turbo work good on my t3
- need help selecting an intercooler + piping
- Turbo XS BOV RFL
- Adjustable 1st gen Mitsubishi BOV
- fastest/most power on dual core cooler?
- Finally, a standalone, cost effective, Holset VGT controller that works!!!!!!!
- Wet Nitrous Kit Fuel tap in?
- removing mitsu turbo with motor in car?
- Compressor map for TO3 Garrett with TO4e compressor wheel
- Anyone ever used a VNT T-28 turbo?
- Plastic piece in early TI discharge hose (deswirler?)
- To DBB or not to DBB
- What turbo to buy?
- Intercooler ~half covered by bumper. Performance Loss?
- Turbo Upgrade Options?
- External WG sizing?
- Clock a vnt turbo?
- Ebay Manual Boost controller
- ported stocker with precision 5431 turbo question
- Exhaust Housing Swap Questions
- 2.4 Turbo recomendaions
- Uhh, this don't look good
- Standard vs Anti-Surge Ported Compressor
- Chrysler .63 turbine measurements
- HX35 on a 8 Valve
- External Wastegate Opening Early
- 2013+ Cummins intercooler on a van
- No boost after crankcase evac
- Boost Leak Testing
- 2.5L l4 Turbo 1
- Turbo upgrade
- what other turbine housings will work with chrysler teo4h?
- Ford .63 AR support bracket, how to?????
- external wastegate
- T04E vs GT Series
- S70 with .48?
- Ported Garrett turbo project
- awd omni srt-4 smoking when under boost
- Turbo Oil Leak
- Black Intercoolers Mythbusted
- 92 2.5L turbo intercooler install
- boost problem question
- 87 LeBaron turbo rebuild
- Manual Boost controllers
- he341 holset rebuild and up grade
- cold air intake
- How to increase engine power?
- can i delete the airbox on csx
- Holset Command Valve solenoid
- turbo outlet size?
- 1987 csx bov
- Squirrel performance turbo calculator?
- very low 3rd gear boost mystery??
- Pipe dream bench racing turbo "idea"
- intercooler thickness. How thick before it loses effeciency?
- fast throttle input means low boost, slow throttle gets higher boost
- Supercharge Dodge Daytona Engines?
- Stupid question. Smart answer. Re turbo
- recent 8 valve external wastegate set up pics
- New to Me Sundance, 2.5/Mitsu/523
- Thought I'd share, 66mm x 86mm billet HX40 wheel!
- 1g bov hooked up overboost, take bov out only 7 psi?
- Turbo value
- intercooler questions??
- more intercooler questions
- Name this intercooler.
- What happened to my compressor wheel
- How-To: Create a bracket for your G-Valve on the cheap!
- Air to water intercooler in a wagon
- Anyone ever fit Treadstone trv 1859 IC into Omni?
- just a couple questions for the pro's
- SRT IC in a Pbody?
- Upgraded turbo/ auto trans
- One Piece Intake Modded with 3.8 Neck
- Hey Pat empty your box.
- Hyundai Intercooler
- '89 T2 turbo shelf life?
- 3 core Evo half radiator stuffed in an Omni?
- 2005 PT Cruiser GT Smell
- "intercooler kit" interchangeably?
- just a question
- Front/bottom mount turbo info.
- Oil dist. block
- Boost cutoff?
- Turbine exit hole dia at various stages?
- Wastegate actuator pressure vs extension data
- Dual intercooler.... serial vs parallel???
- How to identify Indy S60 IC?
- Holset VGTs and drive pressure discussion.... Aries_turbo look!
- Turbos unleashed blow off valve
- change vacuum´s
- NEED little help on turbos
- need turbo ideas
- MHI TE04H opimization
- Who's running a T3/T4 turbo with a .48 turbine housing? Looking for results.
- G body I/C rad into an L body - HOW?
- Turbonetics Hurricane "Erin"
- turbo for 85 Shelby
- Wastegate control pro's and con's
- High PSI Manual Boost Controller
- Anyone using a porsche 944 intercooler?
- Turbo porting question.
- PT Cruiser first Turbo Change out advice needed
- Question about MBC on 91 Spirit R/T
- Turbo coolant line around head
- ATP's Chrysler 3" V-band swingvalve out of stock!
- Blow off valve
- Giant intercooler in a minivan.
- VNT's and BOV's
- Van hates internal wastegates
- Need SE Michigan shop for IC Pipes & Exhaust
- Effects of elevation on turbocharged vehicles
- PCV, valve cover spigot and turbo input hose connections
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.