View Full Version : "I need help!"
Pages :
1
2
3
4
5
[
6]
7
8
9
10
11
12
13
14
15
16
17
- Sputtering and popping at 3300 rpm
- Bolts on crank pulley stripped....
- I need help diagnosing an ignition problem on a saturn
- What am I hearing?
- I appreciate the help, but i need more! **PICS!
- Help With Blowby
- Where is all my oil going??
- Idle problems on 87 GLHS
- Oil in Lower and Upper Intercooler hoses.
- help!!!!!!!!!!! No power untill 3500
- help wire bulk head
- Now my Neon has NO brakes!
- Mallory Hyfire VI question.....
- So...the GTS is down again...
- Computer limiting boost to 5 PSI!
- 3bar setup question
- No power to fuel pump.
- help with 84 tona
- Neon Headlight prob.
- innovate LM1 question
- I'm back! With questions...
- Charger idles at 3000rpm and wont go down!
- Sugar in the tank??
- help with transmission issue
- Lbody heater Control Vacuum Lines
- Warm engine restart rough idle stall
- Compression Test Results... Any Suggestions?
- 523/568 into L body
- GLHS PM's
- Not so great Gas Mileage.
- Car dies while cruising?
- sputters at any speed.
- Very loud ticking
- new parts do i need a 255 walbro
- Valve Cover head bolt holes?
- Car won't start
- Won't start after converting to newer style coil
- r/t a/c the same as reg a/c
- dumb question about pulling a t3
- Burning oil at idle
- Help needed -88 Chrysler ES in Belarus
- 3.0 getting too hot.
- 2004 neon sohc cam sensor question?
- after all the new parts question
- Car studder when at wot
- Removal of emblem glue?
- t3 overheating
- oil everywhere!!!
- Heater core replacement, remove dash??
- 3.0L fuel issue
- Not emergency, but still need help paintball paint removal
- Daytona issues.
- Crankshaft sprocket bolt size?
- Smoked out
- Need Advice on Driving 3 Bar Car with 2 Bar SMEC
- k-frame nut
- E-Brake Handle (L-body) Pops up while driving
- Need help asap! N/A tank vs turbo gas tank.
- Need a Socketed SMEC ASAP
- Bad HEP?
- O2 or HEP?
- Fuel sock from hell!!!!
- Headlight switch failure
- Classic Tilt Wheel Repair Stuck :(
- "0" overlap cam
- Front strut question
- Clutch
- ck light on in 3.0 shadow
- Low Boost issue T-2
- Speaking install qeustion.
- Prime the oil system?
- cam curtain
- 91 v6 SBEC Code 62??????
- window guides
- '87 GLHS Falling on it's Face
- SC TII wont boost right!
- idle problems, but it makes no sense to me?
- car leaks oil, clutch wont engage???
- no fuel pump run on 91 jeep help
- new engine now new problems
- Torque Plate
- What trans mount for minivan?
- Car stumbles at 3 mins or so.
- out of town and the dash lights quit
- Is my engine ok?
- please help 85 sc
- Oil Sender Hex necessary?
- Speed/Distance sensor location?
- hello
- Cooling fan issue
- Codes 15, 25, 35
- Breaking up and boost issues
- looking for some one in E. TN or within 7 hours of
- Stock Fuelpressureregulator Vacuum Source
- Turbo Mini leaves me stranded at the track
- slow idiling down
- just got the 2.5 started, specs for fuel pressure and timing needed
- flex plate install 413
- I think i broke it.Help!
- Stuck swing valve
- Inst. cluster problems!!!!
- L-body alternator tensioner help
- TBI: which port is fuel in and fuel out?
- 91 Shadow High Idle Help Please
- Possible blown head gasket?
- ?? on 88 Daytona Shelby Z
- 6 bolt flexplate vs 8 bolt
- torque specs
- Key STUCK in Ignition RUNNING...
- K&N Crankcase breather p/n?
- Engine sputters at 4000rpm's under boost!!
- dodge spirit gas mileage?
- BOTH fuel strap bolts broken...now what
- Trouble after conversion...
- need help on poorly running 84 laser 2.2 turbo
- need help on poorly running 84 laser 2.2 turbo
- Need Help Rocker Arm Keep Poping Out Dont Know Why Help Plz
- Tire issue I think....
- Blown fusible link
- cooling issues!
- Diff Trouble....
- cooling issues,... i think?
- Sundance Issues
- Wastegate/swingvalve not opening?
- Wheel studs, need a part #
- 89 Daytona Shelby Fog light circuit...help
- super 60 external pump fittings
- Crankcase pressure buildup?
- leaking sunroof... rain :(
- Need some help/Knowledge
- Quick 3bar map question
- Vacuum line ? Have to know ASAP
- fresh 3.0L swap - No Start
- LH (drivers side) lower ball joint/control arm help
- Speedometer works - Odometer does not!
- Runs great in first to rev limiter, then......
- have a 450 mile trip for work monday and dont have 1st or 2nd
- Changing clutch
- i need a pic of the bracket that holds shifter cables
- Power Loss lamp lit
- Trans Mount?
- cam timing or something else
- Hole in rad
- Bringing up the boost problem
- Lower control arms
- Pre-wideband exhaust leak cause eratic idle?
- wheres my 1984 chrysler laser turbo map sensor located???
- HELP need an A-555 part.
- Plugged cat
- Proper way to install the Oil Pan Gasket
- How do you test fuel pump relay?
- Looking for a performance chip for a 84 laser
- Bigger exhaust ... wonky boost
- Blown HG? :(
- Annoying stutter/hesitation
- O2 wiring
- Atl Ac Help?
- Bobble strut part number
- A413 Broken axle?
- help how can i install my parts
- help i lost my instructions of my mp 60 computer
- FWD Tubo time?
- horrible sputter!!
- Blew Engine Aain... Need Advice
- No start..tried everything!! (UGH)
- need more boost out of an 84 chrysler lazer
- Eliminating Needless Vacuum Lines (N/A Car)
- bad turbo. got to stop this smoke!
- Codes 41 and 47
- Oil Restrictor
- Ignition problems need help quick
- 91tbi tona just shut off
- Axle
- Easiest way to pull clutch
- Sway bar in backwards?
- pulls to the right then left
- Innovate data log hook up
- smoke!
- running lean at 10 psi
- Idle ?'s
- lean, or wideband help
- negative battery cable carries current (hot)
- Boost trouble
- 3bar whoas...
- t2 swap idling rough and engine light
- Electrical issues, wont start
- wobbling under any acceleration
- boost problems
- Need Help Identifying Master Cylinders
- intermittent brakes
- cut out after 3500
- need help with alt
- HELP: Key Is Stuck In The Ignition!
- Apply the brakes and engine stalls, Resolved
- '89 Lebaron 2.2 turbo1, car not starting properly
- What is this noise
- Need an exhaust manifold ASAP
- 87 GLHS Slow and only 2-5 psi boost?
- Please help. I dont wanna pull the head again.
- Resources for assembling an engine
- Oil Dipstick Tube broken....
- Anybody install a drain plug in a 555 or 568???
- parking brake adjuster
- Turbo noise!
- Quick qeustion on brakes...
- PCV Part #: Needed
- Vacuum Attachment to Wastegate and Purge Solenoid
- First Start after swapping Turbo - Please help
- Code #62.....What Is It..???
- Low / No Oil Pressure
- Bottom end rattle...
- Head Troubles in turbo van...
- Engine cutting out w/more than 80% throttle
- Prop Valve Indentification
- Fuel Pump Not Working
- copper head shim question...
- Whats going on?
- no start, code 34
- Re Ring ?'s
- POP (there) goes the BOOST!??
- no power above 3500 rpm?
- TM Member Needs Help- Indianapolis
- having serious oil issues!!!!
- lack of power/pull
- what the safe max bore for a 2.2?
- missing fusible link - 88 Shelby Z TII
- dumping coolant from turbo side of engine
- how to remove axles? pulling engine/trans together, need help!
- Changed Oil Pump now Runs Like Crap
- Carb spacer block needed asap.
- vacuums
- Flexplate which side is engine side?
- check engine light (and code) is stumping me!!
- Burning Oil/ Possibly because fuel mixture is too rich?
- Downpipe from FWD performance
- Here's a weird one
- Help, my fuel pressure is out of control!
- felpro or mopar performance head gasket
- popping noise don't know what its from...
- 4.0 Turbo Wj
- 2001 Malibu cooling problems again!!
- '87 LeBaron 2.2 turbo
- What the hell is this? ('85 Plymouth Turismo)
- need help! i think my 525 is trying to tell me something?
- '92 Grand Am master cylinder
- Code 54, what do I do?
- Leaking oil - headgasket
- o2 sensor... replace ?
- skipping problem
- Mopar Performance Headbolts. 2 washers?
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.