View Full Version : "I need help!"
Pages :
1
2
3
4
5
6
7
8
9
10
11
12
13
[
14]
15
16
17
- pegged lean at cruise and constant creep to lean? (NON turbo NON dodge)
- pcm 4517636 1989 shelby
- Steering Rack & Pinion - 89 Shelby Dakota
- 1987 Dodge Daytona Pacificia
- Will a 2,000 lb hitch be sufficient to tow a charger?
- Neon code P1391 can't figure out why!
- im reposting have not got much reply still NO SPARK
- Small surface crack imbetween valves
- Overheating Spirit R/T
- Heater/AC Operation 1993 5th Ave ATC
- wiring for change analog to digital cluster 84-86
- Remove small panel to change drivers side oil seal at differential/CV joint on A-413?
- Help, Canadian friends...send scans of speedometer face PLEASE!!!
- Fuel gauge needle location.
- Individual Piston Ring Set
- violent hesitation
- MeanMini A/C re-installation problems
- Anybody have some info on my fuel cut out issue?
- smoking, and popping
- idoling
- The tona' needs to be put together!
- shelby z camshaft seal
- What could cause this ???
- No lights, need help
- problem with digital cluster 84-86 odometer memory chip
- shelby charger window regulator
- Intercooler decision!
- Stage 2 1985 Cailbration Smoking
- Code 42 - ASD relay
- 2.2L TII A/C Idler Pully Bolt and Spacer Specification
- Vibraton Under Hard Acceleration at Low Speed
- Intercooler mounting!
- Back of 2 piece intake to the brake booster...
- Broken in Michigan City Indiana
- Wiring harness!
- running without the turbo?
- Forged or no?
- This is an Odd one.....
- Bad fuel injector???
- Weird TPS problem maybe....
- Steering loose
- well after dbr11 hooked up to the daytona i know more.
- External check engine light
- Erratric idle when cold
- daytona will run today
- Gremlin in the TC?
- spend the last week getting car to starte but ildes up once then stalles
- Misfire above 5k
- keep coming up with code 14
- Code 21 on new O2 Sensor
- A413 2-3 shifting isues
- 85' Lebaron GTS. Power window wire placement?
- +1mm Valves and questions..
- anti-rattle clips K-H single pin calipers
- Best place to put a switch
- Two unrelated issues: Boost and shifter
- 2.2 non-common block Rod Bearings
- a/f ratio question AND smoke problem question
- Smoke after fresh turbo rebuild.
- well after 2 or 3weeks i have got no code but i don,t no why it won,t stayrunning
- Power Loss Light - Dodge Omni GLH-T
- were do i find if i have turbo map
- Halfshaft problems!
- TU DD Pressure Plate clutch pedal Issue
- 1984 Laser - No voltage before coil
- 89 Chrysler New Yorker 3.0L - Need ATC self-diagnostic error codes
- snap ring is absolutely stuck in the housing
- Coolant leak 1990 Dodge Omni
- octane? 87 cut it or do I need 93?
- CHRA balancing vs just turbo shaft balancing??
- won,t stay running
- 89 sundance turbo to 94 shadow motor swap
- can anybody send me a pic. of map and barr sensor in a 91 shadow
- ok i pick up junk yard map+brawo
- Mini van has lost its heat inside
- TIII motor problems. HELP!!!
- oil smoke!?
- howto prime a motor after it has sit for a year?
- 87 Daytona side marker lights
- Flexplate bolt torque specs (or link to all torque specs for Slug)
- Couple of Clutch Questions
- just posted a vid of my car
- help adjusting Shift linkage
- fires up and dies con't
- Piece of the CHRA's edge has fallen apart!!! please QUICKLY
- Car shakes after drags
- clutch problem
- Oil changes - low mileage car
- WHich of theese is the "spring Oring" in the turbine side?
- 2.5 liter turbo 89 lebaron testing of wastegate solenoid
- Daytona suspension or axles problems Help!
- Bubbling in Rad hose
- stripped valve cover bolt
- Overcharging, missfire and Power Loss light.
- Father's 96 Caravan no-start, 3rd time now
- Help!!!
- Stubborn Suspension Bolt
- 5 volt signal refrence?
- Cam decision
- speedo sensor bolt size?
- L body Passenger side motor mount part #?
- non rpm to rpm gauge swap
- GLH Accident
- fuel line question
- Power loss light GLHS
- help finding basic manuals for a 86 shelby charger
- How to clean this off the turbine shaft?
- Pulsing Lamps
- Heater core on 87 CSX
- I need rick dioago's user name
- need to know were to hook my gvavle up
- is this scoring in the bearing housing OK?:/
- working i ilde curce
- Parasitic Battery Drain on a 93 Shadow
- Replacing stock TII radiator fan motor
- Strange idle and symptoms
- any contact with turbomanvan
- rear brake drum dis-assembly issue
- Engine cut out at cruising speeds.
- car wont start
- help with water temp gauge install
- 2 questions
- starter question
- Speedo problems
- Crazy Voltage Spike
- Paint Removal
- Coolant Fan runs all the time...
- Where to buy valves and springs
- cuts out randomly
- Idle Speed Question; 89 Dodge Lancer Shelby Turbo II
- signs of a bad hep / distributer plastic welds
- Bad Misfire / backfiring when shifting
- car cut out at lower gear
- brake caliper confusion
- lowering a daytona
- What NOW??? Alternator Adjuster Rubber Thing-a-ma-bob failure, dammit...
- 87 New Yorker Turbo
- Headlight Adjusters
- Misfire at idle and cruise
- Odd brake caliper clips.
- oil pressure light on after driving 15min
- HELP!!Needing a chip burned with stock calibration
- wipers won't park
- non TM air seperation tank for coolant
- fuel rail
- auxilary shaft seal retainer question
- CHRYSLER E-CLASS 2.2 turbo speed sensor
- Boost Level, TPS or throttle cable related?
- External regulator mod and check engine light on
- T II vacuum hose help needed
- Horrible wobble, pull to the right...
- 85 GLH-T stock boost?
- 86 daytona z that has been t2 swap need to know some wirering abount map
- part throttle drivability problems / rough idle / no accel unless floored
- Smoking!? And not the tires :(
- Part numbers, please!
- At wits end with air conditioning
- Every gear is forward on A413
- ???Green box under the dash????
- In-car TOB change ?
- MAP sensor voltage to high
- getting code 31!!!
- Looking to buy a car. Need some advice on what to troubleshoot
- Shelby Lancer, Auto Tranny not Kicking down
- Need good pics of modified intercooler / turbo piping and blow off
- Vacuum problem driving me NUTS!!!!!!!!
- Shifter bushing
- Slug needs a turbine housing.
- Code 11 no start stranded.
- Installed 360° thrust bearing ( T25G ) but it has some play...?
- high idle
- Random tach missfire/tach drops, and high RPM cylinder drop out
- Headgasket torque pattern/sequence
- Vacuum solenoid - 1989 daytona t2
- Compressor Maps for GT 4502R
- Cometic HG question
- wrist pin clearence
- Intake exhaust and fuel rail bolt sizes
- where to get 0.005 oversize journal bearing for Garrett T28?
- stranded with code 54
- To boost it or not to boost a n/a 2.5?
- runs good after start then dies out
- runs for 20 seconds then idles like crap and dies
- Intermediate shaft bearing woe's
- 87 daytona shelby z no start
- Car stumbles/misses upon acceleration
- Turbo smoke?
- code 36 and smoke please help!
- 1989 daytona T-Tops vs other model years ??
- stuck in the middle of a t2 conv.
- 86 Daytona electrical gremlins....
- HELP PLEASE. Alternator Problems, Dead Battery, Cant Drive Like This
- Running lean while cold
- what gage wire to ran?
- Help me fix my large pile of crap
- 88 Dakota Coolant Leak
- Did I install this clutch right?
- Looking for reputable shop/person to work on 87 CSX in NJ area...
- K frame dillema
- More TII conversion problems
- Help me fix my large pile of crap - Part 2
- 05 PT GT failed inspection CEL
- Multiple Codes 1985 Turbo I to 1986 Turbo II Conversion
- Getting excessive oil into all cylinders
- key got stuck in the ignition.
- new motor problems need help bad!!!!
- map wires plug end
- Oil smoke in boost
- Low Boost, fast spool
- Installing valve seals - how to
- Parts 1988 Horizon how to hot wire?
- Dang it! Fusible links!
- 15 volts in my commuter Sundance!!!
- very bad fuel mileage...please help
- Proof torque for 11mm head bolts?
- code 11 no start after new engine install
- ECU and Turbo help SOHC
- head gasket HELP!!
- No start - no fire
- Removing turbo and manifolds in vehicle Slugmobile
- trouble after engine was replaced
- TBI Vac line routing?
- Brakes won't bleed! Weird...
- Engine cutting out - HELP
- How many rpm at 70mph?
- Needing to have a Head Gasket replaced on turbo car
- What's the secret to reinstalling valve locks on the car?
- Interior gizmos not working
- Questions on head replacement.
- Windshield wiper removal on a P-Body
- Smokes BAD after decel or idle - what's up with that!?
- '87 Shelby Charger: Idle 'jumped'/stayed high, while in neutral after a long ride...
- Boost gauge acting weird
- piston slap? rocker off? bad camshaft? bad lifter?
- M&H slick size advice/recommendation for Slugmobile
- Infinity CD system in 92 Iroc R/T
- 1992 Daytona Vs 1990 Daytona K-frame?
- Under hood lamp bulb type and other questions
- '85 Turbo Z - Bucking Like Mad
- 98 grand cherokee alarm issue
- Valve cover bolt problems.
- Another brake bleeding thread
- Need to make hp
- No start 1988 dodge shadow please help.
- Daytona Track Width?
- daytona stoped out of the blue
- Digital Cluster parts
- Engine clank /knock
- Trans fluid
- Starter won't do anything!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.