Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles Knowledge Center Knowledge Center
  • A.J.'s Avatar
    Today, 12:03 PM
    If and when these come to fruition I'll probably be in for two sets. Just blew out the snap ring retainer tangs on my forward (rear most) clutch...
    49 replies | 6426 view(s)
  • 4 l-bodies's Avatar
    Today, 11:30 AM
    4 l-bodies replied to a thread Red Baron in Project Log
    When I installed a Masi 16v in 86 GLHS I had a similar feeling. Referred to it as the deathmobile. That car had so much torque steer at high speeds...
    66 replies | 18680 view(s)
  • csxtra's Avatar
    Today, 11:25 AM
    csxtra replied to a thread Red Baron in Project Log
    Spiro, First of all, awesome build and thanks for sharing it all with us! I am looking at retrofitting one of the Volvo EHPS pumps into my CSX...
    66 replies | 18680 view(s)
  • boots's Avatar
    Today, 10:27 AM
    Yea a lot of R/D going into it. But they should have been done already. I do weld braces, run billet ring/pinion and pinion support. I've never ran...
    49 replies | 6426 view(s)
  • TwistedGray's Avatar
    Today, 09:54 AM
    TwistedGray replied to a thread For Sale 1984 Chrysler Laser XE Turbo in Cars
    In that case, I am sure she is thrilled!
    17 replies | 901 view(s)
  • 5DIGITS's Avatar
    Today, 09:05 AM
    5DIGITS replied to a thread 1987 csx stumble in "I need help!"
    All, The common failure in the PM, regarding voltage regulation, is the solder joint at the regulator itself. It's typically easy to find because...
    30 replies | 364 view(s)
  • cordes's Avatar
    Yesterday, 11:23 PM
    cordes replied to a thread Red Baron in Project Log
    Thanks for that writeup about the pump. That's a lot of amps at full load. That and the headlight system in my Newyorker would be enough to tax one...
    66 replies | 18680 view(s)
  • cordes's Avatar
    Yesterday, 10:45 PM
    Thanks for that info Todd. That would be an attractive way to shave a little rotating mass while making life easier when it comes to adjusting cam...
    10 replies | 121 view(s)
  • cordes's Avatar
    Yesterday, 10:35 PM
    cordes replied to a thread For Sale 1984 Chrysler Laser XE Turbo in Cars
    The value of my wife's car has skyrocketed if we're basing the market off of this car.
    17 replies | 901 view(s)
  • tryingbe's Avatar
    Yesterday, 10:12 PM
    tryingbe replied to a thread Red Baron in Project Log
    I thought my GLH's engine bay is tight. Good job.
    66 replies | 18680 view(s)
  • spiro440's Avatar
    Yesterday, 09:10 PM
    spiro440 replied to a thread Red Baron in Project Log
    Well I have been wipping around now for over 1000km's (600 miles). Everything is running strong. I detunned it down a little to 425whp/375tq. The car...
    66 replies | 18680 view(s)
More Activity